Dorman - OE Solutions Suspension Ball Joint P/N:536-446
Dorman 536-280 front upper ball joint for the 1965-1969 Ford Mustang and other vehicles joins the control arm to the steering knuckle and lets the wheel pivot. This Dorman ball joint is a threaded, bolt-on design with a tapered stud, and it replaces the failed joint instead of the complete assembly.
A worn suspension ball joint can show up as a clunk over bumps, loose or wandering steering, or uneven tire wear. A worn tie rod end, control arm bushing or wheel bearing can produce similar signs, so find the cause before buying a part.
This ball joint is listed for a wide range of Ford and Mercury models, led by the 1965-1969 Ford Mustang, the 1970 Ford Maverick and the 1968-1969 Ford Fairlane. It is a direct-fit replacement for these vehicles. If your car is not named here, open the "Vehicles it fits" section and look up your exact model, year and engine.
Fit and size
Build and materials
One ball joint with its dust boot, plus mounting hardware and nuts. A grease fitting and bushings are not included. This listing holds one ball joint and the fitment calls for two per car, so order two and fit them together.
Interchange: C70Z3049A
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this Mustang ball joint right for a 1965-1969 Ford Mustang?
Yes. Dorman 536-280 is listed as a front upper ball joint for the 1965-1969 Ford Mustang, and the fitment calls for two per car.
Is this a Ford Maverick ball joint for a 1970 Ford Maverick?
Yes. This front upper ball joint is listed for the 1970 Ford Maverick, and the fitment calls for two per car.
Does this ball joint come with its dust boot and mounting hardware?
Yes. It comes with the dust boot, mounting hardware and nuts. A grease fitting and bushings are not included, and the joint is not greaseable.
What are the stud thread size and taper on Dorman 536-280?
The stud thread is 14 mm in diameter with a 1.5 mm pitch and a 35.5 mm thread length. The tapered stud ends measure 27.2 mm and 22 mm, with a taper of 2 in per foot.
Do I need a special tool to install this threaded ball joint?
A ball joint press tool is typically required to install this ball joint. The 4 mounting holes bolt the joint on with the included hardware.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.