Dorman - OE Solutions Suspension Ball Joint P/N:536-995
Dorman 536-446 front lower ball joint for the 2008-2009 Saturn Astra and other vehicles connects the control arm to the steering knuckle and lets the wheel pivot. It is a direct replacement that fits and performs like the original equipment on specific vehicles.
A worn suspension ball joint can show up as a clunk over bumps, loose or wandering steering, or uneven tire wear. Worn bushings, tires or other steering parts can give similar symptoms, so find the cause before you replace the joint, and leave the test for play to a shop, since it needs the car raised.
It is listed for a wide range of Saturn, Chevrolet and Cadillac models, such as the 2000-2008 Chevrolet Astra and the 2002-2006 Chevrolet Zafira. This listing is one ball joint, and the 2008-2009 Saturn Astra takes two, so order two and fit them together. If your car is not named here, open the "Vehicles it fits" section to check your exact model and engine.
Fit and size
Build and materials
One ball joint, one nut, four bolts and three washers. A grease fitting, bushings, castle nut and cotter pin are not included, so plan on new ones rather than reusing old ones if your setup needs them.
Interchange: TC687 · FA80957 · 352800 · 90512982 · 90542995 · K80957 · MS50506 · JBJ100
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this the right Astra ball joint for a 2000-2008 Chevrolet Astra?
Yes. Dorman 536-446 is a front lower ball joint listed for the 2000-2008 Chevrolet Astra, and the 2008-2009 Saturn Astra is covered too.
Does the Dorman 536-446 come with a nut and bolts?
Yes. It includes the ball joint, one nut, four bolts and three washers. A grease fitting, bushings, castle nut and cotter pin are not included.
Can I grease this Dorman ball joint?
No. This ball joint is not greaseable and has no grease fitting. It has a polymer bearing and a polychloroprene dust boot.
What signs can mean a front lower ball joint is worn?
A clunk over bumps, loose or wandering steering, or uneven tire wear can mean a worn joint. A visible tear in the dust boot is another sign to have looked at.
Do I need a special tool to install the Dorman 536-446 ball joint?
A ball joint press tool is normally needed, since Dorman 536-446 mounts press-in into a 45 mm housing bore.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.