Dorman - OE Solutions Suspension Control Arm Bushing P/N:532-142
Dorman 532-398 rear outer control arm bushing for the 2004-2006 Dodge Verna and other vehicles gives the control arm a rubber-cushioned pivot point. Also sold as a suspension control arm bushing, it lets you replace the worn bushing alone instead of the whole control arm.
A worn control arm bushing can show up as a clunk over bumps, loose or wandering steering feel, or uneven rear tire wear. Before replacing it, look over the rear tires for uneven wear with the engine off, and let a shop confirm the noise comes from this bushing and not another suspension part.
This is a direct-fit replacement for the 2004-2006 Dodge Verna, and it works as a control arm bushing for the 2000-2006 Hyundai Accent too. Both cars need two, one at each rear wheel. This listing is one bushing, and both sides are normally replaced together.
Fit and size
Build and materials
One control arm bushing. Mounting hardware, a bracket and a dust boot are not included, so plan on new hardware rather than reusing the old.
Interchange: TD4612W · FB1024 · 5521925100 · K200003 · K200024 · MK200003 · MS90420 · JBU1984
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this Dorman control arm bushing right for the 2004-2006 Dodge Verna?
Yes. Dorman 532-398 is a rear outer control arm bushing for the 2004-2006 Dodge Verna, and it also fits the 2000-2006 Hyundai Accent.
Does the 532-398 bushing come with bolts or a bracket?
No. This listing is one bushing; mounting hardware, a bracket and a dust boot are not included, so plan on new bolts.
What size is the hole in the Dorman 532-398 bushing?
Dorman 532-398 has a 12.2 mm inside diameter and a 14.3 mm mounting hole diameter. The outside diameter is 60 mm and the wall is 8.53 mm thick.
How can I tell a rear outer control arm bushing is worn?
Cracked or torn rubber, a clunk over bumps or uneven rear tire wear can point to a worn bushing. A shop can inspect it safely.
Is this bushing rubber or all steel?
This bushing is made of rubber and steel, and it has a rust-resistant coating.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.