Dorman - OE Solutions Suspension Control Arm Bushing P/N:540-831
Dorman 540-006 rear upper control arm bushing for the 2003-2006 Ford Expedition and other vehicles cushions the control arm pivot and absorbs road vibration. It is a press-in bushing for the rear upper position at the knuckle.
A worn suspension control arm bushing can mean a clunk over bumps, loose or wandering steering, or uneven tire wear. A ball joint or tie rod can give similar symptoms, so when the old bushing is out during a suspension service, look for cracked, torn or separated rubber and measure it against the sizes below. Otherwise a shop can inspect and test the suspension.
As a control arm bushing for the 2003-2006 Ford Expedition, it is a direct replacement for the original bushing; it also fits the 2003-2006 Lincoln Navigator. This listing is one bushing, and the 2003-2006 Ford Expedition is listed with a quantity of one; the other side of that axle is normally done at the same time.
Fit and size
Build and materials
One control arm bushing. Mounting hardware, a bracket and a dust boot are not included; if the job needs fasteners, plan on new ones, since the old ones may not be reusable.
Interchange: 610.65037
TD5724W · 6L1Z5A838A · K80212 · GK80212 · MK80212 · JBJ1050
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this a control arm bushing for the 2003-2006 Lincoln Navigator?
Yes. Dorman 540-006 is listed for the 2003-2006 Lincoln Navigator, with a quantity of one per vehicle in the fitment.
Does Dorman 540-006 come with a bracket or dust boot?
No. This listing is one control arm bushing. Mounting hardware, a bracket and a dust boot are not included.
What are the inside and outside diameters of this rear upper bushing?
The inside diameter is 14.3 mm and the outside diameter is 40.7 mm. The length is 61 mm and the wall thickness is 13.65 mm.
Is this control arm bushing press-in or bolt-in?
It is a press-in bushing made of rubber and steel, with a rust-resistant coating.
What are the signs of a worn rear upper control arm bushing?
A clunk over bumps, loose or wandering steering and uneven tire wear can be signs of a worn bushing. Cracked or torn rubber is a visible one.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.