Dorman - OE Solutions Suspension Control Arm P/N:520-421
Dorman 520-464 front right lower control arm for the 1996-2002 Toyota 4Runner connects the wheel to the chassis and guides it as the suspension moves. It is a direct replacement, precision-engineered to match the design and dimensions of original components.
A worn control arm or bushing can show up as a clunk over bumps, a car that pulls or wanders, or uneven tire wear. Before you replace the arm, rule out worn ball joints, tie rod ends, shocks and wheel bearings, which can produce similar symptoms.
It fits the 1996-2002 Toyota 4Runner. This listing is one arm for the front right; the front left is a separate part, and both sides are normally replaced together. Each side of the front axle takes one.
Fit and size
Build and materials
One control arm with its bushings. The ball joint, grease fitting and mounting hardware are not included, so plan on new bolts rather than reusing the old ones.
Interchange: 102-6716
CA12160 · 5CB86053 · RK640426 · FA3102 · GS86111 · CMS86111 · 2606101 · SRK640426 · X50CJ7045 · JTC2500 · 4806835080 · 4806835081
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this 1996-2002 Toyota 4Runner lower control arm for the front right or the left side?
It is the front right lower arm. Dorman 520-464 fits the 1996-2002 Toyota 4Runner, and the left side is a separate part.
Does this Dorman control arm include the bushings?
Yes, the bushings come with the arm. The ball joint, grease fitting and mounting hardware are not included.
What is this suspension control arm made of and how is it finished?
Dorman 520-464 is a steel arm with a powder-coated finish and rubber bushings. It is a casting/forged type with a press-in end 2.
What can a worn control arm bushing feel like?
A worn bushing or arm can show up as a clunk over bumps, a car that wanders or pulls, or uneven tire wear. A shop can check the suspension to find the cause.
How large are the bushings on this control arm?
The bushing is 39.6 mm outside diameter, 14.3 mm inside diameter and 92 mm long. The arm itself measures 262.5 mm in length.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.