Dorman - OE Solutions Suspension Control Arm P/N:521-856
Dorman 520-856 front right lower control arm for the 2001-2005 Hyundai Sonata and other vehicles connects the wheel to the chassis. This Dorman control arm is a direct replacement that fits and performs like the original equipment.
A clunk over bumps, uneven tire wear or steering that pulls to one side can mean a control arm or its bushings are worn. These signs alone don't prove this arm is at fault, since a worn tie rod end can feel similar. This listing is one arm for the front right; the front left is a separate part, and both sides are normally replaced together.
The 2001-2005 Hyundai Sonata, 2001-2006 Kia Optima and 2004-2006 Kia Amanti take this part, as do other vehicles, and the front right position uses one arm. That makes it a 2001-2005 Hyundai Sonata lower control arm for the front right.
Fit and size
Build and materials
One control arm with its bushings. A ball joint, a grease fitting and mounting hardware are not included, so plan on new bolts.
Interchange: 102-6105 · 102-6107
TC2384 · TC7581 · CA14259 · 5450138011 · 5450138620 · 5CB90041 · 5CB90059 · 545013F000 · RK640407 · RK641110 · FA3122 · GS90121 · CMS90121 · CMS90145 · 2606121 · 2606137 · SRK640408
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is the Dorman 520-856 the right 2001-2005 Hyundai Sonata control arm for the front right side?
Yes. Dorman 520-856 is the front right lower arm for the 2001-2005 Hyundai Sonata. For a car the page does not name, look up your year and model in the "Vehicles it fits" section.
Does this 2001-2006 Kia Optima control arm fit the front right lower position?
Yes. Dorman 520-856 fits the 2001-2006 Kia Optima at the front right lower position. The front left side is a separate part.
Does this Dorman suspension control arm come with bushings?
Yes, one control arm with its bushings. A ball joint, a grease fitting and mounting hardware are not included.
What size are the bushings on the Dorman 520-856?
The rubber bushings measure 14.3 mm inside diameter, 39.6 mm outside diameter and 92 mm long. The steel arm itself is 262.5 mm long.
Does Dorman 520-856 replace the 545013F000 control arm?
Yes. 545013F000 is one of the numbers this arm replaces, and it is printed on the Interchange line of this page.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.