Dorman - OE Solutions Suspension Control Arm P/N:521-117
Dorman 521-664 front right lower control arm for the 2005-2010 Kia Sportage and other vehicles connects the wheel assembly to the vehicle and guides suspension movement.
A worn lower control arm can show up as a clunk over bumps, a pull to one side or uneven front-tire wear, and tired bushings or other suspension parts can produce those signs too. With the engine off, look the front tires over for uneven wear, and have a shop inspect the suspension before you replace the arm.
This control arm is a direct replacement for the 2005-2010 Kia Sportage and the 2005-2009 Hyundai Tucson, engineered to the design and dimensions of the original components. This listing is one arm for the front right; the front axle has one lower arm per side, and the left one is a separate part that is normally replaced at the same time.
Fit and size
Build and materials
One control arm with its rubber bushings. A ball joint, mounting hardware and a grease fitting are not included, so plan on new mounting bolts, since the old ones may not be reusable.
Interchange: 850-0320 · 101-6072 · 102-6072
TC3200 · CA12364 · 545012E100 · 5CB90268 · 545011F000 · 545011F100 · 545012E000 · 545012E001 · RK641339 · GS90161 · CMS90161 · 2606837 · SK521664 · X23CJ2033 · JTC2594
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this the right 2005-2010 Kia Sportage control arm for the front right side?
Yes. Dorman 521-664 is the front right lower control arm for the 2005-2010 Kia Sportage. The left side of the axle takes its own arm.
Is this a 2005-2009 Hyundai Tucson lower arm for the front right?
Yes. Dorman 521-664 fits the front right lower position on the 2005-2009 Hyundai Tucson. The front left side uses a separate part.
Does this Dorman control arm come with bushings and a ball joint?
Yes to the bushings: they are rubber and included. No ball joint, mounting hardware or grease fitting is included, so plan on new bolts.
What are the bushing sizes on this Dorman lower control arm?
The rubber bushing is 14.3 mm inside diameter, 39.6 mm outside diameter and 92 mm long. The mounting holes are 505.1 mm apart.
What can I look for on a worn Dorman suspension control arm?
Look for cracks, a bent arm or torn or separated rubber in the bushings, with the engine off. In driving, a clunk over bumps or vibration through the steering can have several causes, and a shop can pin them down.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.