Dorman - OE Solutions Suspension Control Arm P/N:524-251
Dorman 524-020 front right lower control arm for the 1995-2004 Toyota Tacoma links the wheel assembly to the frame. This Dorman control arm lets the wheel travel with the suspension while holding its position.
A clunk over bumps, a loose steering feel or uneven tire wear can mean a lower control arm or its bushings are worn, though a ball joint or a tie rod end can be behind the same signs, so find the cause before replacing the arm.
It is a direct replacement for the 1995-2004 Toyota Tacoma, which takes one lower arm on each side of the front axle. This listing is one arm, for the front right; the front left is a separate part, and the two are normally replaced together.
Fit and size
Build and materials
One control arm with its bushings, which saves time and labor on installation. A ball joint, mounting hardware and a grease fitting are not included, so plan on new fasteners because the old ones may not be reusable.
Interchange: 102-7989 · 622.44914
TC6244 · CA12691 · 9CB86108 · RK640891 · GS86184 · CMS86184 · 2606442 · 2606442M · 1525042 · JTC2779 · 4806804010 · 4806804011 · 4806835060 · 4806835061 · 4806835120
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this one of the A-arms for the 1995-2004 Toyota Tacoma?
Yes. Dorman 524-020 is a front right lower control arm for the 1995-2004 Toyota Tacoma, and the front left side is a separate part.
Does the Dorman suspension control arm 524-020 come with a ball joint?
No. Dorman 524-020 has no ball joint and none is pre-installed, but the bushings are included. Mounting hardware and a grease fitting are not included either.
What is this control arm made of, and how big are its bushings?
The arm is stamped steel with a powder-coated finish, and its bushings are rubber. The bushings measure 14.3 mm inside diameter, 39.6 mm outside diameter and 92 mm long.
How do I tell if the bushings on this lower control arm are worn?
Drivers can notice a clunk over bumps, a loose steering feel or uneven tire wear. A shop can inspect the arm and its bushings, and cracked rubber or a bent arm means replacing it promptly.
Does Dorman 524-020 replace the arm listed under 102-7989?
Yes. 102-7989 is one of the other numbers that Dorman 524-020 replaces. The rest are on the Interchange line.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.