Dorman - OE Solutions Suspension Stabilizer Bar Link Kit P/N:542-536
$39.99
(You save)
Keep the rear stabilizer bar tied to the suspension so it can do its job limiting body roll, with the Dorman - OE Solutions Suspension Stabilizer Bar Link Kit 542-536. This rear sway bar link drops in as a direct-fit replacement for the 1993-1995 Toyota Land Cruiser [All], where each vehicle uses two links — order a pair to renew both sides.
Steel construction: built with a coated finish for rust and corrosion resistance.
Greaseable design: includes a grease fitting and polymer bearings, with a dust boot to help keep contaminants out; it is not pre-greased.
Connection ends: one end is a 10.4 mm mounting hole, the other a 14 mm male-threaded stud with a 1.5 mm thread pitch; overall length is 82.5 mm.
Included hardware: comes with locking nuts. Bushings, washers, bolts, sleeves and spacers are not included.
A stabilizer bar link connects the sway bar to the suspension so the bar can resist lean during cornering. Worn links may knock or rattle over bumps and let the body sway more than usual; if a failed link is the cause, this kit replaces it. Precision-engineered and tested to match the design and dimensions of the original. Country of origin: Taiwan.
It's a direct-fit replacement for the 1993-1995 Toyota Land Cruiser [All]. Each vehicle uses two rear links, so order a pair. Check the Buyer's Guide tab to confirm your vehicle.
Is this a front or rear stabilizer bar link kit?
It is cataloged as a rear suspension stabilizer bar link kit for the listed applications.
Is this link greaseable?
Yes. It has a greaseable design with a grease fitting and polymer bearings. It is not pre-greased, so grease it per the vehicle service procedure.
What hardware is included?
The kit includes locking nuts and a dust boot. Bushings, washers, bolts, sleeves and spacers are not included; consult the service information for any additional fasteners.
What are the link's dimensions and ends?
Overall length is 82.5 mm. One end is a 10.4 mm mounting hole and the other is a 14 mm male-threaded stud with a 1.5 mm thread pitch.
Write a Review
Dorman
Dorman - OE Solutions Suspension Stabilizer Bar Link Kit P/N:542-536
Help keep your Sienna's front end composed through turns with the Dorman OE Solutions Sway Bar Link Kit, part number 542-542. It is a direct-fit front replacement for the 2011-2020 Toyota Sienna. It...
Keep rear body roll in check with the Dorman - OE Solutions Suspension Stabilizer Bar Link Kit (542-227), a direct-fit rear stabilizer bar link that installs and performs like the original on the...
The Dorman - OE Solutions Suspension Stabilizer Bar Link Kit (542-360) links the front stabilizer bar to the suspension, transferring load between the two sides so the bar can limit body roll and...
Keep your stabilizer bar tied into the suspension and help control body lean through corners with the Dorman - OE Solutions Suspension Stabilizer Bar Link Kit 542-800. This front sway bar link...
Quiet a clunking, rattling rear suspension and keep the stabilizer bar tied to the suspension with the Dorman - OE Solutions Suspension Stabilizer Bar Link Kit 542-400. This sway bar link connects...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
