Raybestos Brakes Disc Brake Caliper P/N:FRC11880N
Raybestos Brakes FRC4126 front left brake caliper for the 1978-1983 Chevrolet Malibu and other vehicles squeezes the brake pads against the rotor to slow the wheel. This remanufactured disc brake caliper is a semi-loaded floating design.
Pulling to one side, brake fluid around the piston boot or unevenly worn pads may mean a caliper is failing. With the engine off and the brakes cool, look for fluid around the caliper and hose; a brake service can check the guide pins and pad wear, so the cause is found before you replace the caliper. For the 1978-1983 Chevrolet Malibu, this listing is one caliper for the front left; the front right is ordered separately, and the two are normally replaced together.
The caliper for the 1978-1983 Chevy Malibu is one of many listed for a wide range of models from Chevrolet, GMC, Pontiac, Buick, Oldsmobile and other makes, including the 1982-1992 Chevrolet Camaro and the 1982-2003 Chevrolet S10. If your car is not named here, look it up in the "Vehicles it fits" section.
Fit and size
Build and materials
Product information is for general reference and may contain errors. See our Disclaimer.
Is the FRC4126 a Camaro brake caliper for the 1982-1992 Chevrolet Camaro?
Yes, the Raybestos Brakes FRC4126 is listed for the 1982-1992 Chevrolet Camaro. It is a front left caliper; the front right side is a separate part.
Does the FRC4126 work as an S10 brake caliper on a 1982-2003 Chevrolet S10?
Yes, the 1982-2003 Chevrolet S10 is on the fitment list for this front left caliper. For other models, look in the "Vehicles it fits" section.
What size is the piston on the Raybestos R-Line FRC4126?
The Raybestos Brakes FRC4126 has a 63.5 mm (2.5 in) piston and an M10x1.5 bleeder screw thread. It is a floating caliper with a cast iron casting.
Which parts are replaced with new ones in this remanufactured caliper?
Seals, boots, bleeder screws, abutment hardware, banjo bolts and O-rings are replaced with new materials. Castings, guide pins and brackets are inspected before they are reused.
Can a sticking caliper make the car pull to one side?
It can, but worn pads, a tire problem or a hose can also pull a car to one side. A shop can check the caliper, pads and hose during a brake service.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.