Left Heater Hose for 2012-2016 Tesla Motors & More - Gates 12483

$38.99

Vehicles this part fits

    Part number: 12483
    UPC: 770075841807
    Condition: New
    Weight: 2.74 LBS
    Item Package Quantity: 1
    $38.99
    Adding to cart… The item has been added

    Have questions?

    Gates HVAC Heater Hose P/N:12483
    Gates HVAC Heater Hose P/N:12483
    $38.99
    $38.99

    Keep coolant flowing through the heater circuit with the GATES heater hose 12483, a factory-molded, OE-style replacement cataloged for the 2012-2016 Tesla Motors and 2012-2016 Tesla S. This ThermalPro Premium molded coolant hose is built to fit tighter, smaller engine compartments and is listed for the reservoir-to-pump (left) position, so it follows the original coolant routing on the listed applications.

    • Molded construction: factory-molded, OE-style design — a true GATES molded heater hose shaped to the routing rather than a cut length of straight hose.
    • EPDM build: EPDM tube, synthetic fiber knit reinforcement, and an EPDM cover, engineered to resist electrochemical degradation, a leading cause of hose failure.
    • Rated specs: meets SAE 20R3 Type EC Class D-1 and D-2, with a temperature range of -40°F to 275°F (-40°C to 135°C).

    Approved for coolant, water, and air applications, and also cleared for marine use. Do not use it for fuel or oil transfer. Gates recommends fitting new hose clamps whenever a coolant hose is installed. This GATES hvac heater hose helps restore the factory heater-circuit connection when the original has hardened, cracked, or begun to seep.

    Interchange: F10639 · 13483 · R45029 · 103785500D

    Product information is for general reference and may contain errors. See our Disclaimer.

    This part cross-references / interchanges with the following part numbers:

    F10639, 12483, 13483, R45029, 103785500D

    Frequently Asked Questions

    What vehicles does the GATES 12483 fit?

    It is cataloged for the 2012-2016 Tesla Motors and 2012-2016 Tesla S. Check the "Vehicles it fits" section to confirm the engine and position for your vehicle.

    Where does this heater hose install?

    It is cataloged for the reservoir-to-pump (left) position, following the factory coolant routing on the listed applications.

    What is this GATES hvac heater hose made of?

    It uses an EPDM tube, synthetic fiber knit reinforcement, and an EPDM cover, and meets SAE 20R3 Type EC Class D-1 and D-2 specifications.

    Can I use this hose for fuel or oil?

    No. Gates cautions against fuel or oil transfer. It is approved for coolant, water, and air applications, and is also cleared for marine use.

    Should I replace the hose clamps?

    Yes. Gates recommends installing new hose clamps each time a new coolant hose is fitted.

    Reviews

    No reviews yet — be the first to review this product.

    Write a Review