Gates 21611 upper radiator coolant hose for the 1987-1991 Toyota Camry 4-cylinder 2.0L and other vehicles carries coolant between the engine and the radiator. This Gates molded coolant hose is a replacement for an upper hose that has aged or failed.
Cracks, bulges, soft or collapsed spots and coolant seepage at the hose ends can mean an upper hose is failing. Before you replace this hose, rule out a loose clamp or a leak elsewhere in the cooling system, and inspect hoses only with the engine off and cool.
The fitment spans a wide range of Toyota, Dodge, Plymouth and Mitsubishi models, including the 1984-1990 Dodge Colt 4-cylinder 1.6L and the 1984-1990 Plymouth Colt 4-cylinder 1.6L. If your car is not named here, look it up in the "Vehicles it fits" section of the product page.
Fit and size
Build and materials
One upper radiator coolant hose. This listing is a single hose, and one hose goes on each car.
Interchange: MH-4611 · 14-2527-4 · KM-1583
24199L · H0061318 · D71618 · F11028 · MB222357 · MB356045 · MB356506 · MB536506 · 8120 · 8329 · 1657103020 · 1657174030 · 1657174050 · 1657174080 · 1657174090 · C1423 · C1611
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Does the Gates 21611 hose fit the 1987-1991 Toyota Camry 4-cylinder 2.0L?
Yes. Gates 21611 is listed for the 1987-1991 Toyota Camry 4-cylinder 2.0L. For other cars, look in the "Vehicles it fits" section on the product page.
Is this Gates coolant hose made of EPDM?
Yes. Gates 21611 has an EPDM tube and an EPDM cover over synthetic fiber knit reinforcement, and the cover resists heat, ozone and chemical coolants.
What are the inside diameters and length of this upper hose?
Both ends of Gates 21611 have a 1.12 in (28 mm) inside diameter. The centerline length is 17.9 in (455 mm).
Should I put new clamps on when I install this hose?
Yes. Fresh hose clamps are recommended each time a new coolant hose is installed, so replace the old clamps when you put Gates 21611 on.
Which standards does this molded hose meet?
This hose meets SAE 20R4, class D2 and DIN 73411, class A, except for tolerances. Its temperature range is -40 Deg. F to +257 Deg. F.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
