Hitachi Astemo Engine Camshaft Position Sensor Kit P/N:CPS20508KIT
Give the ECU an accurate read on camshaft position with the Hitachi Astemo Engine Camshaft Position Sensor Kit (CPS20508KIT). It's a direct-fit replacement for a wide range of Nissan and Infiniti applications, including the 2003-2008 INFINITI FX35 [V6-3.5L], 2003-2007 INFINITI G35 [V6-3.5L], 2002-2004 INFINITI I35 [V6-3.5L], 2003-2006 NISSAN 350Z [V6-3.5L], 2002-2008 NISSAN MAXIMA [V6-3.5L], and 2005-2018 NISSAN FRONTIER [V6-4.0L] — see the Buyer's Guide tab for the full list.
The camshaft position sensor signals your vehicle's Electronic Control Unit (ECU) the position of the engine's camshaft, which the ECU uses to manage timing. Hitachi designs each sensor to meet the exact needs of the specific vehicle.
- New OE part: supplied new and described by Hitachi as an actual OE part.
- 3 blade terminals: three-terminal blade design with a male connector.
- Single mounting hole: one mount hole for installation.
- Country of origin: Japan.
Signs the original sensor may need replacing include hard starting, stalling, rough running, or an illuminated check engine light. If a failed camshaft position sensor is the cause, this kit replaces it — diagnose the cause before replacing.
Manufacturer part number CPS20508KIT.
Frequently Asked Questions
What does this camshaft position sensor kit do?
It signals your vehicle's Electronic Control Unit (ECU) the position of the engine's camshaft, which the ECU uses to manage timing.
Which vehicles does the CPS20508KIT fit?
It fits many Nissan and Infiniti V6-3.5L and V6-4.0L applications, such as the FX35, G35, 350Z, Maxima, Frontier and Xterra. See the Buyer's Guide tab for the full list.
Is this a new part?
Yes. It is supplied new and described by Hitachi as an actual OE part.
What are signs my camshaft position sensor may need replacing?
Common signs include hard starting, stalling, rough running, or an illuminated check engine light. Diagnose the cause first, since these symptoms can have other sources.
Where is this sensor made and what connector does it use?
Country of origin is Japan. It uses a three-blade terminal design with a male connector and a single mounting hole.
Write a Review