Dial in your front-end alignment with the Mevotech Supreme Alignment Cam Bolt Kit MS250175, a direct-fit replacement for the 2005-2010 Dodge Dakota and 2006-2009 Mitsubishi Raider. This front cam bolt kit replaces the factory adjustment hardware, giving you a controlled way to reset camber and caster back into specification during suspension service or after installing new components.
Adjustment range: provides camber/caster correction of ±2.00°, letting you fine-tune the front wheel angles within that range.
- Front position: designed for the front suspension of the listed applications.
- Alignment correction: the eccentric cam bolt rotates to shift the control arm or knuckle, moving the wheel angle so you can bring camber and caster into the target setting.
- Direct-fit hardware: replaces the original cam bolt hardware on the specified vehicles.
If worn alignment bolts, uneven tire wear, or a suspension repair have left your front alignment out of specification, this kit supplies the adjusting hardware needed to set it right. Have the vehicle professionally aligned after installation.
Interchange: K100164 · K100165 · 82400
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
K100164, K100165, MS250175, 82400
Frequently Asked Questions
What vehicles does the MS250175 cam bolt kit fit?
It fits the front suspension of the 2005-2010 Dodge Dakota and 2006-2009 Mitsubishi Raider. Check the "Vehicles it fits" section to confirm it matches your vehicle.
What does an alignment cam bolt kit do?
The eccentric cam bolt rotates to move the control arm or knuckle, shifting the wheel angle so camber and caster can be adjusted into specification.
How much adjustment does this kit provide?
It provides a camber/caster adjustment range of ±2.00°, allowing the front wheel angles to be fine-tuned within that range.
Is this kit for the front or rear?
This is a front alignment cam bolt kit, designed for the front suspension of the listed applications.
Do I need an alignment after installing this kit?
Yes. After installing the cam bolts, have the vehicle professionally aligned so camber and caster are set to the correct specification.
