Mevotech Supreme Suspension Control Arm Bushing P/N:MS30497
Keep your front suspension tight and controlled with the Mevotech Supreme Control Arm Bushing (MK9870), a front lower bushing that cushions the pivot where the control arm attaches to the chassis. It installs as a direct-fit replacement on the 1989-1998 Chevrolet Tracker, 1989-1997 Geo Tracker and 1989-1998 Suzuki Sidekick — see the "Vehicles it fits" section for engine-level fitment.
This suspension control arm bushing absorbs road shock and helps locate the control arm so the wheel can hold its intended geometry through bumps and cornering.
As the rubber ages it can crack or separate, showing up as clunking over bumps, vague steering or uneven tire wear. If worn control arm bushings are the cause, replacing them addresses that wear — diagnose the cause before ordering, and inspect the matching bushing on the other side.
Interchange: 101-5941 · 101-6287 · 602.48003 · 602.48004
1015941 · 1016287 · 60248003 · 60248004 · ATM 1033603 · ATM 1033605 · ATM 1033610 · 19291063 · BGK9870 · BCK73025 · BCK73025PR · FB758 · K9870 · BU09030 · IK9870 · 1K9870 · GK9870 · 100789 · 17807 · 5651271 · 5651277 · 931912044 · 931914007
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
What does this control arm bushing do?
It cushions the pivot where the control arm meets the chassis, absorbing road shock and helping locate the arm so the wheel keeps its intended alignment geometry through bumps and cornering.
What vehicles does the MK9870 fit?
It fits the 1989-1998 Chevrolet Tracker, 1989-1997 Geo Tracker and 1989-1998 Suzuki Sidekick. Check the "Vehicles it fits" section for engine-level fitment on your vehicle.
What is this bushing made of?
It is built with high-grade natural rubber construction, intended to hold up under the repeated loads of front suspension use.
Where is this bushing located on the vehicle?
It serves the front lower control arm mounting point, cushioning where that arm pivots against the chassis.
What are signs the bushing may need replacing?
Cracked or separated rubber, clunking over bumps, vague steering or uneven tire wear can signal worn bushings. Diagnose the cause first, since these symptoms can have other sources.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.