Monroe Shocks & Struts Air Shock Absorber P/N:MA835
Monroe Shocks & Struts MA817 rear shock absorber for the 1978-1995 Chevrolet G10 and other vehicles holds the rear at level height under load with an air chamber. Load capacity is limited by the vehicle's suspension, tires and transmission; see the owner's manual.
Fluid on the shock body, a rear end that sags or bounces, or an air fitting that will not hold pressure can mean the shock is worn or leaking. Before you replace it, rule out a worn bushing, a damaged air line or fitting and a spring problem, since those can look much alike. Rear shocks are normally replaced in pairs on the same axle.
The 1978-1995 Chevrolet G10, the 1978-1995 Chevrolet G20 and the 1979-1995 GMC G1500 are among the vehicles it fits, and it fits more. Open the "Vehicles it fits" section to look up your exact model and engine. The catalog lists a quantity of one per application for the 1978-1995 Chevrolet G20.
Fit and size
Build and materials
Rear air shock absorber with its dust shield and boot.
Interchange: 49212
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Will the Monroe MA817 fit a 1978-1995 Chevrolet G10?
Yes. Monroe Shocks & Struts MA817 is listed as a rear shock absorber for the 1978-1995 Chevrolet G10. For other models, open the "Vehicles it fits" section.
How much weight and air pressure can the Max-Air MA817 handle?
The air chamber inflates or deflates up to 150 PSI to maintain level height with up to 1,200 lbs of added weight. Capacity is limited by suspension, tires and transmission.
How do I inflate this Max-Air rear shock?
On the Monroe MA817, the air fitting ties into the factory system where applicable, or you can inflate it with an air compressor. Monroe air shock accessory and shock air hose AK kits pair with it, depending on the application.
Does this air shock come with a dust shield and boot?
Yes. The dust shield and the boot are both included with this rear air shock absorber, and the dust shield is rubber.
What are the compressed and extended lengths of this rear air shock?
Compressed length is 12.75 in (323.8 mm), extended length is 20.875 in (530.2 mm) and travel is 8.125 in. Both ends use a loop bushing and sleeve mount.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.