Skip the spring compressor and finish your MONROE easy strut job in a single bolt-in step with the Monroe Quick-Strut Suspension Strut and Coil Spring Assembly 271498, a rear right unit built to help restore controlled ride on the 1999-2003 Lexus RX300 and 2001-2003 Toyota Highlander. This MONROE quick strut assembly arrives fully preassembled, so the strut, coil spring and upper mount install together as one complete strut and coil spring assembly.
Monroe fit checks and ride tests its Quick-Strut assemblies, and this one is backed by Monroe's Limited Lifetime Warranty and Feel the Difference Guarantee. See the Buyer's Guide tab for full engine-level fitment.
Interchange: LS5494042R · 33TY1180
This part cross-references / interchanges with the following part numbers:
What is the MONROE suspension strut and coil spring assembly 271498?
It is a rear right Monroe Quick-Strut unit with a preassembled strut, coil spring and upper mount that installs as one piece, so no spring compressor is needed.
What vehicles does this MONROE strut assembly fit?
It fits the 1999-2003 Lexus RX300 and the 2001-2003 Toyota Highlander. Check the Buyer's Guide tab for engine-level fitment for your vehicle.
Which position on the vehicle is this strut for?
This assembly is for the rear right suspension corner.
Do I need a spring compressor to install it?
No. This MONROE quick strut complete assembly ships fully assembled, so no spring compressor is required for the strut replacement.
Should I replace both rear struts at the same time?
Replacing struts in matched pairs is a common best practice for balanced ride and handling. This listing is for one rear right assembly.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
