Nugeon 97-01569A front left brake caliper for the 1995-2004 Toyota Tacoma clamps the brake pads against the rotor to slow the wheel. This remanufactured Nugeon brake caliper replaces a worn or leaking front left unit.
A failing caliper can show up as the truck pulling to one side under braking, fluid at the dust boot, or one pad worn thinner than the other. At your next brake service, compare both pad thicknesses and look at the boot for wetness, with the engine off and the brakes cool, to find the cause before you replace the caliper.
This is a direct-fit replacement caliper for the 1995-2004 Toyota Tacoma, which takes one on the front left. This listing is that side only; the front right is ordered separately, and both sides are normally replaced together.
Fit and size
Build and materials
One front left brake caliper with its bleeder screw, dust boots, crush washers, and caliper and pad hardware. Pads, bracket, bracket mounting bolts, mounting bolt, caliper slides, anti-squeal shims, wear sensors and the bleeder screw cap are not included, so plan on new bolts, since the old ones may not be reusable.
Does this front brake caliper fit a 2002 Toyota Tacoma from the 1995-2004 range?
Yes. Nugeon 97-01569A fits the 1995-2004 Toyota Tacoma, which includes the 2002 model year. It is the front left caliper only; the front right is a separate part.
Does this disc brake caliper come with pads or a bracket?
No. This front left caliper comes with the bleeder screw, dust boots, crush washers and hardware. Pads, bracket, bracket bolts and caliper slides are not included.
Is this Nugeon caliper a fixed design, and how many pistons does it have?
Nugeon 97-01569A is a fixed caliper with four steel pistons, each 43 mm (1.693 in) across.
Are the front calipers for the 1995-2004 Toyota Tacoma sold per side?
Yes. This listing is one caliper for the front left; the front right is a separate part, and both sides are normally replaced together.
What thread do the inlet port and bleeder screw use on this caliper?
The inlet port on Nugeon 97-01569A is M10-1.0 x 23.4 mm, and the bleeder screw thread is M10-1.0. The inlet fitting is a banjo bolt.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
