Nugeon Disc Brake Caliper P/N:99P17429B
Nugeon 97B01331A front right brake caliper for the 2006-2014 Subaru Impreza and other vehicles clamps the brake pads against the rotor to slow the wheel. This Nugeon brake caliper is a remanufactured fixed-type unit.
A caliper that is sticking or leaking can show up as the car pulling to one side when you brake, brake fluid around the caliper, or one pad wearing faster than the others. Before you replace the caliper, rule out worn pads, a rotor in poor shape or a collapsed brake hose, since each of those can produce similar symptoms.
This caliper is a direct-fit replacement for the 2006-2014 Subaru Impreza and the 2013-2017 Subaru WRX STI. On the 2006-2014 Subaru Impreza, the front right position takes one caliper; the front left is its own part, and the two sides are normally replaced together.
Fit and size
Build and materials
One brake caliper with its bleeder screw, dust boots, crush washer and mounting hardware. Brake pads, anti-squeal shims, the bracket, bracket and mounting bolts, slides, caliper and pad hardware, wear sensors and the bleeder screw cap are not included, so plan on new bolts.
Product information is for general reference and may contain errors. See our Disclaimer.
Are the calipers for the 2006-2014 Subaru Impreza sold one per side?
Yes. Nugeon 97B01331A is a single front right caliper for the 2006-2014 Subaru Impreza; the front left is a separate part, and both sides are normally replaced together.
Is this a front right brake caliper for the 2013-2017 Subaru WRX STI?
Yes. Nugeon 97B01331A fits the 2013-2017 Subaru WRX STI at the front right position.
Is this remanufactured disc brake caliper sold with brake pads?
No. This caliper comes with its bleeder screw, dust boots, crush washer and mounting hardware. Pads, anti-squeal shims, the bracket and slides are not included.
What size are the pistons on this Nugeon caliper?
This caliper has four aluminum pistons, with outside diameters of 40 mm (1.575 in) and 46 mm (1.811 in).
What thread does the banjo bolt inlet on this brake caliper use?
The inlet port is M10-1.0 x 23.4 mm and takes a banjo bolt. The bleeder screw on Nugeon 97B01331A is M10-1.0.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.