Nugeon 99-01003B rear left brake caliper for the 1991-1997 Honda Accord and other vehicles clamps the brake pads against the rotor to slow the wheel. This remanufactured Nugeon brake caliper is a floating-type disc brake caliper.
A pull to one side, uneven pad wear or fluid around the piston boot can mean a caliper is sticking or leaking. These signs alone do not prove the caliper is at fault, since a collapsed brake hose can also make a wheel drag. This listing is one caliper for the rear left, the rear right is a separate part, and both sides are normally replaced together.
Listed for a wide range of Honda and Acura models, it is a 1991-1997 Honda Accord rear caliper and also fits the 1995-1998 Acura TL and the 1992-1994 Acura Vigor, one per rear left position. If your car is not named here, look for it in the "Vehicles it fits" section.
Fit and size
Build and materials
One remanufactured brake caliper with its bracket, caliper slides, caliper and pad hardware, dust boots, bleeder screw with cap and crush washers. Brake pads, anti-squeal shims, wear sensors and bracket mounting bolts are not included, so plan on new mounting bolts.
Interchange / FMSI:
FMSI: D365
Is this Honda Accord caliper for 1991-1997 cars a rear left piece?
Yes, Nugeon 99-01003B is the rear left caliper for the 1991-1997 Honda Accord; the rear right side is a separate part.
Is this Acura TL brake caliper for 1995-1998 cars also listed for Honda models?
Yes, Nugeon 99-01003B is listed for the 1995-1998 Acura TL and the 1991-1997 Honda Accord, one per rear left position. Owners of other models can look up their car in the "Vehicles it fits" section.
What comes with the Nugeon caliper besides the caliper body?
Nugeon 99-01003B includes the bracket, slides, caliper and pad hardware, dust boots, bleeder screw with cap and crush washers. Pads, anti-squeal shims, wear sensors and bracket mounting bolts are not included.
What size is the piston on this rear left caliper?
The caliper has one steel piston, 38 mm (1.5 in) across. The inlet is a banjo bolt fitting with an M10 - 1.0 thread.
What are the signs of a sticking rear brake caliper?
A brake that drags, a burning smell after driving or a pull to one side can mean a caliper is sticking. A brake shop can inspect and test it safely.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
