Nugeon Disc Brake Caliper P/N:99-00600A
Nugeon 99-01236A front left brake caliper for the 2004-2008 Mitsubishi Endeavor clamps the brake pads against the rotor to slow the wheel. This remanufactured Nugeon brake caliper comes with its bracket, slides and dust boots.
Pulling to one side under braking, a burning smell at one wheel or brake fluid around the caliper can mean this caliper is worn or sticking, though a worn brake hose or worn pads can be behind the same symptoms, so find the cause first. Calipers are normally replaced in pairs across an axle; this listing is one caliper for the front left, and the front right is ordered separately. Each side of the front axle takes one.
This caliper fits the 2004-2008 and 2010-2011 Mitsubishi Endeavor.
Fit and size
Build and materials
One caliper with its bracket, slides, dust boots, bleeder screw and crush washers. Brake pads, anti-squeal shims, caliper and pad hardware, bracket mounting bolts, mounting bolts, the bleeder screw cap and wear sensors are not included, so plan on new bolts.
Product information is for general reference and may contain errors. See our Disclaimer.
Is this 2004-2008 Mitsubishi Endeavor brake caliper also right for the 2010-2011 model years?
Yes. Nugeon 99-01236A fits the 2004-2008 and 2010-2011 Mitsubishi Endeavor, and it is made for the front left side.
Does the Nugeon caliper come with the bracket and slides?
Yes. The bracket, slides, dust boots, bleeder screw and crush washers are included. Brake pads, anti-squeal shims and bracket mounting bolts are not.
Is this disc brake caliper floating or fixed?
Nugeon 99-01236A is a floating caliper with two steel pistons, each 45 mm (1.772 in) in diameter. The body is cast iron.
How can I tell a front left brake caliper is sticking?
Pads worn unevenly from side to side, a pull to one side under braking or a wheel that feels like it drags can mean a sticking caliper. A shop can test it to confirm.
What thread does the inlet on this caliper use?
The inlet takes a banjo bolt with an M10-1.0 x 27.32 mm port thread. The bleeder screw thread is M8-1.0.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.