Nugeon Disc Brake Caliper P/N:99-02317A
Nugeon 99-02003B front right brake caliper for the 2014-2016 Mazda 3 and other vehicles presses the brake pads against the rotor to slow the wheel. This remanufactured Nugeon brake caliper has a floating design with one piston.
A failing disc brake caliper can show up as the car pulling to one side, or as fluid around the caliper. Before you replace the caliper, rule out the pads, the brake hose and the rotor as the source of the pull or drag.
As a brake caliper for the 2014-2016 Mazda 3, it is a direct-fit replacement, and it also fits the 2014-2016 Mazda 3 Sport.
Fit and size
Build and materials
One front right caliper with its mounting bracket, caliper slides, dust boots, caliper and pad hardware, bleeder screw with cap and crush washer. Pads, wear sensors, anti-squeal shims and bracket mounting bolts are not included, so plan on new bolts rather than reusing old ones. This listing holds one caliper, and the front right takes one; the front left is its own part, ordered separately, and the two sides are normally replaced together.
Interchange / FMSI:
FMSI: D1759
Product information is for general reference and may contain errors. See our Disclaimer.
Is this a front right caliper replacement for the 2014-2016 Mazda 3?
Yes. Nugeon 99-02003B is the front right caliper for the 2014-2016 Mazda 3 and also fits the 2014-2016 Mazda 3 Sport; the left side is a separate part.
Does the Nugeon caliper come with brake pads?
No. Nugeon 99-02003B comes without pads, wear sensors, anti-squeal shims and bracket mounting bolts; the bracket, slides, dust boots, bleeder screw and crush washer are included.
What thread size is the brake line fitting on this caliper?
The inlet is a banjo bolt fitting with an M10 - 1.0 thread, and the bleeder screw is M8-1.0.
What signs can point to a failing front right brake caliper?
The car can pull to one side, or you can find fluid around the caliper or uneven pad wear during a brake service. A shop can test the caliper itself.
Is the Nugeon 99-02003B caliper housing made of cast iron?
Yes. The housing is cast iron and the piston is steel, with a rust preventative finish.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.