Nugeon Disc Brake Caliper P/N:99-00600A
TERREPOWER 99-02426A rear right brake caliper for the 2014-2017 BMW i8 and other vehicles clamps the brake pads against the rotor to slow the wheel. It is a remanufactured floating caliper.
A sticking or leaking caliper can show up as the car pulling to one side, a pad worn much more than its mate on the other side, or fluid around the dust boot. If this caliper is the cause, this one replaces it. At your next brake service, with the brakes cool, look at the boot and compare pad wear side to side before you decide.
Beyond the 2014-2017 BMW i8, this rear right brake caliper fits the 2011-2016 BMW 528i and the 2012-2016 BMW 528i xDrive. Open the "Vehicles it fits" section to check your exact model and engine. On the 2011-2016 BMW 528i, this listing is one caliper for the rear right; the rear left is a separate part, and the other side of that axle is normally done at the same time.
Fit and size
Build and materials
One remanufactured rear right brake caliper with its mounting bracket, caliper slides, dust boots, bleeder screw and crush washers. Brake pads, anti-squeal shims, wear sensors, caliper and pad hardware, the bleeder screw cap and the bolts for the bracket and caliper are not included; plan on new bolts rather than reusing the old ones.
Product information is for general reference and may contain errors. See our Disclaimer.
Does this fit as one of the 2014-2017 BMW i8 brake calipers?
Yes. TERREPOWER 99-02426A is the rear right caliper for the 2014-2017 BMW i8, and the 2019-2020 BMW i8 is listed too. For another model or engine, open the "Vehicles it fits" section.
Does the 99-02426A caliper come with its bracket and slides?
Yes. This caliper includes the mounting bracket, caliper slides, dust boots, bleeder screw and crush washers. Brake pads, shims, wear sensors, the bleeder screw cap and the mounting bolts are not included.
What piston does the TERREPOWER 99-02426A caliper have?
TERREPOWER 99-02426A has one steel piston, 44 mm (1.732 in) in diameter, in a floating caliper design.
How can I tell if a disc brake caliper is sticking or leaking?
At a brake service, with the brakes cool, look for fluid around the dust boot and for pad wear that differs from side to side. A car pulling to one side can also be a sign; a shop can test the caliper.
What thread does the bleeder screw on this remanufactured caliper use?
The bleeder screw thread is M10-1.0. This rear right caliper's inlet port thread is also M10-1.0.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.