Nugeon Disc Brake Caliper P/N:99-17383A
Nugeon 99-03364A front left brake caliper for the 2005-2018 Volkswagen Jetta and other vehicles slows the wheel by pressing the brake pads against the rotor. This remanufactured Nugeon brake caliper replaces a unit that leaks or sticks.
A sticking or leaking disc brake caliper can show up as the car pulling to one side under braking, a burning smell from one wheel, or brake fluid around the caliper. These signs alone do not prove the caliper is at fault; a collapsed brake hose can cause a pull as well.
It fits the 2005-2018 Volkswagen Jetta and the 2009-2017 Volkswagen CC, and it is also a VW Passat brake caliper for 2006-2010 cars, along with other models. This listing is one caliper for the front left wheel; the front right is a separate part, usually replaced at the same time. If your car is not named here, open the "Vehicles it fits" section to check your exact model and engine.
Fit and size
Build and materials
One caliper with its mounting bracket, caliper slides, dust boots, caliper and pad hardware, bleeder screw and crush washers. Brake pads, anti-squeal shims, wear sensors, the bleeder screw cap and the bracket mounting bolts are not included, so plan on new bolts, since the old ones may not be reusable.
Product information is for general reference and may contain errors. See our Disclaimer.
Will this front left caliper fit the 2005-2018 Volkswagen Jetta?
Yes. Nugeon 99-03364A fits the 2005-2018 Volkswagen Jetta on the front left side. For another car, open the "Vehicles it fits" section and look up your exact model and engine.
Is this among the Volkswagen CC brake calipers for 2009-2017?
Yes. Nugeon 99-03364A fits the 2009-2017 Volkswagen CC on the front left side. The front right takes its own separate caliper.
Does the Nugeon caliper come with brake pads?
No. Pads, anti-squeal shims, wear sensors and bracket mounting bolts are not included. The caliper comes with its bracket, slides, dust boots, hardware, bleeder screw and crush washers.
What size is the piston on this remanufactured caliper?
This floating caliper has one steel piston, 54 mm (2.126 in) across, with a piston outside diameter of 53.95 mm (2.12 in).
What banjo fitting thread does this front left caliper use?
Nugeon 99-03364A has a banjo inlet with an M10-1.5 x 23.14 mm port thread, and crush washers are included. The bleeder screw thread is M10-1.0 x 28 mm.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.