Nugeon Disc Brake Caliper P/N:99-01156B
Nugeon 99-17907A front right brake caliper for the 2004-2007 Ford E-150 and other vehicles clamps the brake pads against the rotor to slow the wheel. This remanufactured floating disc brake caliper replaces a caliper that sticks or leaks at the front right wheel.
A car that pulls to one side when braking, a brake that drags, or fluid around the dust boot can point to a caliper that is sticking or leaking. Before you replace it, use a brake service to look at how evenly the pads wore and whether the dust boot is wet, since a hose or the pads can give a similar pull.
This caliper fits the 2004-2007 Ford E-150 and the 2004-2005 Ford E-150 Club Wagon, one per front right wheel. The listing is a single caliper; the front left is a separate part, and the other caliper on that axle is normally done at the same time.
Fit and size
Build and materials
One brake caliper with its mounting bracket, caliper slides, dust boots, bleeder screw and crush washers. Brake pads, anti-squeal shims, wear sensors, the bleeder screw cap, pad hardware and the bracket mounting bolts are not included, so plan on new bolts for the bracket.
Product information is for general reference and may contain errors. See our Disclaimer.
Is this Nugeon brake caliper the right one for a 2004-2005 Ford E-150 Club Wagon?
Yes. Nugeon 99-17907A is a front right caliper that fits the 2004-2005 Ford E-150 Club Wagon, and also the 2004-2007 Ford E-150.
Does this caliper come with brake pads?
No. This front right brake caliper is sold without pads, anti-squeal shims or wear sensors. The bracket, slides, dust boots, bleeder screw and crush washers are included.
What size are the pistons in the Nugeon 99-17907A?
The Nugeon 99-17907A is a floating caliper with two phenolic pistons, each 54 mm (2.126 in) in diameter.
Why does my car pull to one side when I brake, and could the caliper be involved?
A pull to one side, a dragging brake or uneven pad wear can mean a caliper is not releasing, though other brake parts can cause them too. A shop can test it.
What bleeder screw size does this Nugeon caliper use?
The bleeder screw is 3/8-24 x 1 and is included, but the bleeder screw cap is not. The inlet uses a banjo bolt with a crush washer.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.