TERREPOWER 99P17331B rear right brake caliper for the 2003-2020 Chevrolet Express 2500 and other vehicles uses hydraulic pressure to press the brake pads against the rotor. This remanufactured disc brake caliper replaces a worn or leaking unit at the rear right wheel.
Signs of a failing caliper can include brake fluid leaking at the wheel, a torn dust boot or one rear pad wearing faster than the other. Before you replace the caliper, rule out a worn brake hose, worn pads or seized slides, which can give a similar pull or drag. Both rear calipers are usually replaced in the same visit, and this listing is one caliper for the right side.
Listed for a wide range of Chevrolet and GMC models, it also fits the 2003-2020 Chevrolet Express 3500 and the 2003-2020 GMC Savana 2500. Look up your own year and model in the "Vehicles it fits" section.
Fit and size
Build and materials
One caliper with its bracket, caliper slides, dust boots, bleeder screw and crush washers. The rear right takes one, and the rear left is ordered separately. Brake pads, anti-squeal shims, wear sensors, the bleeder screw cap, caliper and pad hardware and bracket mounting bolts are not included, and the old bolts may not be reusable, so plan on new ones.
Is this TERREPOWER 99P17331B the right brake caliper for the 2003-2020 Chevrolet Express 3500?
Yes. The TERREPOWER 99P17331B rear right brake caliper is listed for the 2003-2020 Chevrolet Express 3500. Check your own vehicle in the "Vehicles it fits" section.
Does the TERREPOWER rear right caliper come with its bracket?
Yes. The bracket, caliper slides, dust boots, bleeder screw and crush washers are included. Brake pads, bracket mounting bolts and anti-squeal shims are not.
What size are the pistons on this remanufactured caliper?
The TERREPOWER 99P17331B has two phenolic pistons with a 51 mm (2.008 in) diameter.
How can I tell if a rear brake caliper is sticking?
A sticking caliper can show up as the vehicle pulling to one side, a burning smell after driving or a rear wheel that seems to drag. A shop can confirm it.
Does this caliper use a banjo bolt, and what is the port thread?
Yes. The inlet fitting is a banjo bolt, and the inlet port thread is M10-1.0 x 27.32 mm. The bleeder screw on this rear caliper is M10-1.0.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
