Keep lubricant in and road grit out with the SKF wheel seal 18865, a direct-fit replacement for the listed applications. It fits many vehicles, among them the 1983-1988 Toyota Cressida, 1982-1985 Toyota Celica and 1974-1981 Toyota Corona. It is cataloged for the front, rear outer position. See the "Vehicles it fits" section for the full list and engine specifics.
A wheel seal closes off the hub so the bearing's lubricant stays inside and dirt and water stay outside.
SKF has long led in seal design and development. It invented the first integrated shaft seal in 1928 and has continued to pioneer new designs and bonding techniques since then. Each SKF seal follows a specific design and uses premium materials so the seal suits both its application and its operating environment.
Signs this part may need replacing include grease or oil seeping at the wheel, lubricant on the brake components, or a torn or hardened seal lip. Diagnose the source of any leak before you replace the seal.
Interchange: 052-1450 · 052-2151 · TO-001-1 · 90311-48122
0521450 · 0522151 · TO0011 · 9031148122 · 4134484100 · 224820 · 27SS4484
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
What does the SKF 18865 wheel seal do?
It seals the wheel hub area. It keeps the bearing's lubricant in and keeps dirt and water out.
Which vehicles does the SKF 18865 fit?
It fits many vehicles, among them the 1983-1988 Toyota Cressida, 1982-1985 Toyota Celica and 1974-1981 Toyota Corona. See the "Vehicles it fits" section for the full list and engine details.
Which position is this wheel seal for?
The catalog lists this seal for the front, rear outer position on the listed Toyota applications.
What are signs a wheel seal may need replacing?
Warning signs include grease or oil seeping at the wheel, lubricant on the brake parts, or a torn or hardened seal lip. Diagnose the source of the leak before replacing.
How is the SKF 18865 constructed?
The body is deep drawn sheet steel, which forms a rigid, stress-resistant metal case. The garter spring is made from cold drawn steel wire.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
