Keep the rear glass rising smoothly and holding steady with the Stabilus Back Glass Lift Support 4B-056922 (also written 4B056922), a hydraulically dampened, gas-charged lift support that installs as a direct-fit replacement for the 1984-1990 Ford Bronco II. This is Stabilus' Lift-O-Mat unit, engineered for controlled damping and a measured 17.20-inch length.
- Patented Labyrinth Piston: delivers clog-free, smooth motion through the opening and closing cycle.
- Clog-free design: helps prevent binding caused by contamination.
- Corrosion-resistant coatings: part coatings are tested to automotive standards for corrosion resistance.
- Easy installation: designed to install with no special tools.
Lift-O-Mat pairs an oil-channeling system with the labyrinth piston design, using application-tuned oil viscosities and piston configurations to provide the smooth, controlled damping engineered for this application. Built on the OE design for proper fit, form, and function. If your back glass drops, drifts down, or won't stay raised because a worn lift support is the cause, this replaces it. For best results, replace lift supports in pairs.
Interchange: E4TZ 9842104-B · 819-5564
D95774DL · 84418 · E4TZ9842104B · FLR115 · FLR116 · FLR117 · D95774 · 901218 · 901394 · 901396 · 8195564 · 056922 · 3815LH · 4418 · D4418 · 613233 · G304002 · SG304002 · SG359011 · TSG359011
This part cross-references / interchanges with the following part numbers:
D95774DL, 84418, E4TZ 9842104-B, E4TZ9842104B, FLR115, FLR116, FLR117, D95774, 901218, 901394, 901396, 819-5564, 8195564, 056922, 3815LH, 4418, D4418, 613233, G304002, SG304002, SG359011, TSG359011
