Hold your hood open with a steady, controlled motion using the Stabilus Hood Lift Support 2B-845621, a 29.09-inch gas-charged lift support with dynamic speed control. It's a direct-fit replacement for the 2008-2018 Toyota Sequoia and 2007-2014 Toyota Tundra — see the "Vehicles it fits" section for engine-level details.
- Dynamic damping speed control: Stabilus's Lift-O-Mat design uses a longitudinal groove (velocity manifold) pressed into the tube wall to route gas around the piston, creating a fluid opening motion with no bouncing or jerking during cycling.
- Gentle, controlled stop: the groove profile gradually narrows toward the end of the stroke for a soft finish with minimal impact.
- Corrosion-resistant coatings: part coatings are tested to automotive standards for corrosion resistance.
- Built on the OE design to match proper fit, form, and function, and it installs easily with no special tools.
Lift supports work as a matched pair, so for best results Stabilus recommends replacing both sides together. If a worn or gas-depleted support that no longer holds the hood is the cause, this unit replaces it.
Interchange: 819-7045 · 53440-0C020 · 53440-0C021 · 53450-0C020 · 53450-0C021
B96655DL · B96655 · 901254 · 8197045 · 845621 · 6655 · B6655 · 534400C020 · 534400C020D · 534400C021 · 534500C020 · 534500C020D · 534500C021 · 610194 · SG229026 · TSG229026
This part cross-references / interchanges with the following part numbers:
LS10913, B96655DL, 6655, B6655, B96655, 901254, 819-7045, 8197045, 845621, 53440-0C020, 534400C020, 534400C020D, 53440-0C021, 534400C021, 53450-0C020, 534500C020, 534500C020D, 53450-0C021, 534500C021, 610194, SG229026, TSG229026
Frequently Asked Questions
What vehicles does this hood lift support fit?
It's a direct-fit replacement for the 2008-2018 Toyota Sequoia and 2007-2014 Toyota Tundra. Check the "Vehicles it fits" section to confirm the fit for your specific vehicle.
How long is this lift support?
This gas-charged Stabilus lift support measures 29.09 inches.
Should I replace both supports at once?
Lift supports work as a pair, so Stabilus recommends replacing both sides together for best results and balanced, controlled operation.
What does the dynamic damping do?
A longitudinal velocity-manifold groove in the tube wall routes gas around the piston for a fluid opening motion with no bouncing or jerking, and the profile narrows near the end of the stroke for a gentle stop.
What are signs this lift support may need replacing?
A support that no longer holds the hood up, drops slowly, or opens with a jerky or bouncing motion may indicate a worn or gas-depleted unit that this part can replace.
