Keep your driver-assist electronics reliably connected with the Standard Ignition Blind Spot Detection Sensor Connector / Cruise Control Distance Sensor Connector (S2887) — the connector that rejoins the vehicle wiring harness to the blind spot detection sensor or cruise-control distance (radar) sensor. It fits as a direct-fit replacement for the listed applications, including the 2011-2017 Chrysler 300, 2009-2016 Chrysler Town & Country, 2015-2017 Dodge Challenger, 2011-2018 Dodge Charger, 2012-2013 Dodge Durango, 2009-2016 Dodge Grand Caravan, 2014-2015 Jeep Cherokee, and a broad range of Mercedes-Benz models — see the Buyer's Guide tab for the full list.
A damaged connector can interrupt the power or data between the vehicle and its blind spot monitoring or adaptive cruise sensor, which may set an ADAS warning or leave the system inoperative. Signs this connector may need replacing include corroded, bent, or melted terminals and an intermittent or lost sensor signal after harness work. Because these symptoms can have other causes, diagnose the fault before replacing. Quantity varies by application — some vehicles use one and others use two — so confirm how many your vehicle requires in the Buyer's Guide. This part is cataloged under both names: Blind Spot Detection Sensor Connector and Cruise Control Distance Sensor Connector. Manufacturer part number S2887.
What does the Standard Ignition S2887 connector do?
It is the electrical connector that joins the vehicle wiring harness to the blind spot detection sensor or cruise-control distance (radar) sensor, passing power and signals between them.
Will this connector fit my vehicle?
It is a direct-fit replacement for many Chrysler, Dodge, Jeep, and Mercedes-Benz models. Check the Buyer's Guide tab to confirm your exact year, make, and model.
How many connectors do I need?
Quantity varies by application — some vehicles use one and others use two. Confirm the number your specific vehicle requires in the Buyer's Guide tab before ordering.
What are the signs this connector needs replacing?
Corroded, bent, or melted terminals and an intermittent or lost sensor signal. These symptoms can have other causes, so diagnose the fault before replacing the connector.
Why is it listed under two part-type names?
It is cataloged as both a Blind Spot Detection Sensor Connector and a Cruise Control Distance Sensor Connector because it serves both driver-assist sensor circuits.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
