Standard Ignition HS-392 HVAC blower control switch for the 2007-2008 Honda Fit sets the blower motor speed for the A/C and heater.
- Copper alloy conductors for electrical conductivity with low resistive losses
- 100% tested for both mechanical and electrical switching performance
- Five switch positions with toggle actuation
- Rectangular female connector with six male blade terminals
- Plastic housing
Quick facts
- Part: Standard Ignition HS-392 HVAC blower control switch
- Fits: 2007-2008 Honda Fit
- Material: Plastic
- Condition: New
A blower that works on only some speeds, or not at all, can come from a worn switch, but a fuse, the wiring or the blower motor may be behind it. With the engine off, start by looking at the connector and terminals for melted plastic, burn marks or corrosion; a shop can test the circuit itself.
Fits
This is the switch that fits the 2007-2008 Honda Fit, and the car takes one.
Specifications
Fit and size
- Quantity per vehicle: 1
- Voltage: 12 V
- Switch positions: 5
- Width: 39.878 mm (1.57 in)
- Connector: 1 rectangular, female
- Terminals: 6, male blade
Build and materials
- Housing material: Plastic
- Switch actuation: toggle
- Attachment method: plug in
- Condition: New
- Country of origin: Japan
In the box
One blower control switch. The wiring harness, hardware and mounting bracket are not included.
Interchange: BL120 · SW7562 · HC354 · 79570SAA003
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
BL120, SW7562, HC354, 79570SAA003, HS-392
Frequently Asked Questions
Is this the right blower switch for the 2007-2008 Honda Fit?
Yes. Standard Ignition HS-392 is listed for the 2007-2008 Honda Fit, and the car takes one.
Does the HS-392 blower switch come with a wiring harness or mounting hardware?
No. Standard Ignition HS-392 is the switch only. The wiring harness, hardware and mounting bracket are not included.
What kind of connector does this blower switch have?
This switch has one rectangular female connector with six male blade terminals, and it attaches by plugging in.
My blower only works on some speeds. Could the switch be the problem?
It can be. A switch that skips positions or won't start the blower may be worn, though a fuse, the wiring or the blower motor can produce the same symptoms.
Is the Standard Ignition HS-392 blower switch tested for switching performance?
Yes. Each Standard Ignition HS-392 is 100% tested to verify both its mechanical and its electrical switching performance.
