Standard Ignition Mass Air Flow Sensor P/N:MAS0258
Standard Motor Products
Standard Ignition MAS0335 mass air flow sensor for the 2013-2019 Ford Escape 4-cylinder 2.5L and other vehicles measures the air entering the engine for the ECU. The ECU uses that reading to balance the air/fuel ratio.
Rough idle, hesitation or a check engine light can mean the sensor is worn, though a vacuum leak or a dirty throttle body can be behind the same signs. If the sensor is the cause, this one replaces it.
This is a direct-fit OE replacement, extensively tested to OE specifications, for a wide range of Ford models, including the 2013-2019 Ford Escape 4-cylinder 2.5L, the 2016-2019 Ford F-650 V8 6.7L and the 2016-2019 Ford F-750 V8 6.7L. If you drive another Ford, look up your year, model and engine in the "Vehicles it fits" section.
Fit and size
Build and materials
One mass air flow sensor, without the housing. This listing holds a single sensor, and the vehicle takes one.
Interchange: 2-14174
MA1167 · AFLS166 · BC3Z12B579A
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is the Standard Ignition MAS0335 a 2013 Ford Escape mass air flow sensor with the 4-cylinder 2.5L engine?
Yes, Standard Ignition MAS0335 is listed for the 2013-2019 Ford Escape 4-cylinder 2.5L and the 2016-2019 Ford F-650 V8 6.7L; other vehicles are in the "Vehicles it fits" section.
Does this mass air flow sensor come with its housing?
No, the housing is not included; this listing is the sensor only, and the vehicle takes one.
How many pins are on the MAS0335 connector?
The Standard Ignition MAS0335 has one rectangular female connector with four male pin terminals. It attaches by bolts through two bolt holes.
Can a rough idle or hesitation come from a bad mass air flow sensor?
Yes, a worn sensor can show up as rough idle, hesitation or a check engine light. A shop can read the codes and test the sensor with a scan tool.
How is this mass air flow sensor tested?
Each unit is tested by computer, so the ECU gets accurate airflow readings even under hard engine conditions. It is also extensively tested to OE specifications.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.