Standard Ignition Neutral Safety Switch Connector,Transmission Range Sensor Connector P/N:S-2082
$99.99
(You save)
Repair a corroded, melted, or broken connection without replacing the entire harness with the Standard Ignition Neutral Safety Switch Connector / Transmission Range Sensor Connector S-2082. This factory-assembled pigtail plugs into the neutral safety switch / transmission range sensor circuit and is a direct-fit replacement for a wide range of Chrysler, Dodge, Jeep, Hyundai, Kia, and Mitsubishi applications — including the 2000-2003 Dodge Dakota, 2002-2008 Dodge Ram 1500, 2004-2014 Hyundai Sonata, 2006-2015 Kia Optima, and 2007-2017 Mitsubishi Outlander. See the Buyer's Guide tab for the full list of 46 applications.
Rectangular plastic housing: metal blade terminals with a push-on attachment method.
Harness and splice connectors included: a 17 in (431.8 mm) wiring harness with six splice connectors and 16-gauge wire. No dust shield included.
Tested to OE standards: 100% tested for proper mechanical and electrical fit, form, and function, and built to OE standards in TS16949- and ISO9001-certified facilities.
Replacing just the connector is a cost-effective way to fix a damaged connection rather than swapping the whole harness. Country of origin: Taiwan. This part is cataloged under both the Neutral Safety Switch Connector and Transmission Range Sensor Connector names. Manufacturer part number S-2082 (also S2082).
This part cross-references / interchanges with the following part numbers:
It is the direct-replacement electrical connector (pigtail) for the neutral safety switch / transmission range sensor circuit, letting you splice in a new connector instead of replacing the entire wiring harness.
Will it fit my vehicle?
It is listed for 46 Chrysler, Dodge, Jeep, Hyundai, Kia, and Mitsubishi applications spanning 2000-2020. Check the Buyer's Guide tab to confirm your exact year, make, and model.
What is included?
The wiring harness is included: a 17 in (431.8 mm) harness with six splice connectors and 16-gauge lead wire, factory-assembled for push-on installation. A dust shield is not included.
Is the connector weatherproof?
Yes. It is weatherproof-sealed and weather-resistant.
What are signs this connector may need replacing?
Corroded, melted, loose, or damaged terminals can interrupt the neutral safety switch / transmission range sensor signal. Diagnose the cause first; if the connector is at fault, this replaces it.
Write a Review
STANDARD MOTOR PRODUCTS
Standard Ignition Neutral Safety Switch Connector,Transmission Range Sensor Connector P/N:S-2082
Oxygen Sensor ConnectorDecades of industry leading research and development focused on meeting the technician's needsOffering hundreds of high-quality pigtails and sockets for nearly every electrical...
Clutch Starter Safety Switch ConnectorOur components are manufactured to meet exact OE standards, ensuring high-quality products. We produce them in facilities certified to TS16949 and ISO9001...
Reconnect your transmission range/neutral safety switch cleanly with the Standard Ignition Neutral Safety Switch Connector S-1516. This factory-assembled connector provides the wiring interface...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
