Standard Ignition Starter Drive P/N:SDN-5
Standard Motor Products
Standard Ignition SDN-316 starter drive for the 1987-1988 Nissan Van 4-cylinder 2.4L and other vehicles meshes with the engine's flywheel ring gear when the starter motor spins, so the engine can crank.
A worn starter drive can show up as a grinding noise at startup, a starter that spins without turning the engine, or an engine that will not crank. Before you replace it, rule out a weak battery, corroded cables and the starter motor or solenoid, because those can produce similar signs. These engines take one starter drive each, and this listing is a single drive.
The vehicles it fits include the 1980 Nissan 720 4-cylinder 2.0L, the 1981-1982 720 4-cylinder 2.2L, the 1983 720 4-cylinder 2.4L and the 1982-1986 Chevrolet Chevette 4-cylinder 1.8L.
Interchange: 19113454 · SD609 · 8941155680 · 8942335820 · 8942420660 · 8943118660 · 2331206W60 · 2331207G00 · 23312H9100 · 23312N5900 · 23312V5301 · 23312V5301NA · 2335407G00
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Does the Standard Ignition SDN-316 starter drive fit the 1987-1988 Nissan Van 4-cylinder 2.4L?
Yes. Standard Ignition SDN-316 is listed for the 1987-1988 Nissan Van 4-cylinder 2.4L and for other vehicles too. For any other car, enter its year and engine in the "Vehicles it fits" section to see if it fits.
Will this starter drive work in the 1982-1986 Chevrolet Chevette 4-cylinder 1.8L?
Yes. Standard Ignition SDN-316 is listed for the 1982-1986 Chevrolet Chevette 4-cylinder 1.8L, and that engine takes one starter drive.
Is 23312V5301 an interchange number for the SDN-316 starter drive?
Yes. 23312V5301 is among the numbers this Standard Ignition starter drive replaces, along with SD609 and 19113454.
Can a worn starter drive cause grinding when I start the engine?
Yes, it can. A worn drive may grind as it meshes with the flywheel, or spin without turning the engine over. A shop can test the starting system.
Where is the Standard Ignition SDN-316 starter drive made?
The country of origin for Standard Ignition SDN-316 is the United States. The brand's quality control runs from componentry through the finished product.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.