Move pressurized brake fluid from the hard line to the wheel with the Sunsong Brake Hydraulic Hose 2201206. It installs as a direct-fit replacement across a wide range of 1974-1976 GM cars — including the 1975 Buick Apollo, 1974-1976 Chevrolet Impala, 1974-1976 Oldsmobile 98, and 1974-1976 Pontiac Bonneville (All engines); see the Buyer's Guide tab for the full list of 35 applications.
Signs this hose may need replacing include cracked, bulging, or leaking rubber and a soft or spongy brake pedal; if a failed hose is the cause, this replaces it. The listed applications use two hoses per vehicle, so order the quantity your repair requires — this listing ships one hose.
Interchange: Manufacturer part number 2201206.
This part cross-references / interchanges with the following part numbers:
What does this brake hydraulic hose do?
It carries pressurized brake fluid from the vehicle's steel brake line to the caliper or wheel cylinder, flexing with suspension and steering movement while keeping the hydraulic circuit sealed.
What are the end fittings and their sizes?
One end is a banjo fitting (7/16 in) and the other is a female fitting (3/8 in). The banjo end includes new copper washers to help ensure a proper seal.
What is the hose made of?
The hose uses EPDM, and the tubing is high-grade steel electroplated with a zinc coating for corrosion and rust resistance against humidity, road salt, water, and grime.
How many hoses do I need?
The listed applications use two hoses per vehicle. This listing ships one hose, so order the quantity your repair requires.
Does it meet brake safety standards?
Yes. It is DOT approved and built to meet or exceed DOT, FMVSS 106, and SAE J1401 standards, and each hose is high-pressure tested before leaving the factory.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
