DANA SPICER 2016801 front ball joint kit for the 2007-2017 Jeep Wrangler and other vehicles replaces the upper and lower ball joints on one front side. This DANA SPICER ball joint kit is built to OE standards set by Dana.
- Upper and lower ball joints for one side in a single kit
- Hardware included with the ball joints
- Dana design, engineering, testing and manufacturing processes working together
- Tested and validated to rigorous specifications
Quick facts
- Part: DANA SPICER 2016801 ball joint kit
- Also called: suspension ball joint kit
- Fits: 2007-2017 Jeep Wrangler and other vehicles
- Position: Front
- Condition: New
A clunk over bumps, loose steering or uneven tire wear can mean a ball joint is worn, though worn tie rod ends or wheel bearings can be behind the same signs. This listing is one kit for one side, and the front pair is normally replaced together.
Fits
It also fits the 1978-1979 Ford F-250 and the 2018 Jeep Wrangler JK, along with many other vehicles. Open the "Vehicles it fits" section to check your exact model and engine.
Specifications
Fit and size
- Position: Front
- Quantity per vehicle: 2
- Kit contents: upper and lower ball joints for one side
Build and materials
- Type: ball joint kit, upper and lower, one side
- Hardware: included
- Condition: New
- Country of origin: United States
In the box
One kit with the ball joints for the upper and lower positions of one side, plus hardware. This listing holds one kit, and the vehicle takes two.
Product information is for general reference and may contain errors. See our Disclaimer.
Frequently Asked Questions
Is this the right ball joint for a 2018 Jeep Wrangler JK?
Yes. DANA SPICER 2016801 is listed for the 2018 Jeep Wrangler JK as a front kit, and the vehicle takes two, one for each front side.
Are DANA SPICER ball joints in this listing enough for both front sides?
No. This listing is one kit for one side, and the vehicle takes two kits, one for each front side.
Does this upper and lower ball joint kit come with hardware?
Yes. The kit holds the ball joints for the upper and lower positions of one side, plus hardware.
Is the DANA SPICER 2016801 ball joint kit made in the USA?
Yes. The country of origin for DANA SPICER 2016801 is the United States.
Is this suspension ball joint kit tested to OE specifications?
Yes. It is tested and validated to rigorous OE specifications, and it is built to the OE standards Dana sets.
