Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC2487
$63.99
(You save)
Keep the front wheel located and the ball joint pivoting smoothly through steering and suspension travel with the Delphi control arm TC2487, a front right lower suspension control arm and ball joint assembly that drops in as a direct-fit replacement for the 2001-2003 Kia Rio. Backed by Delphi's OE safety technology fitted to millions of vehicles worldwide, this Kia Rio control arm helps maintain proper steering geometry when the original is worn.
Tested to the extreme: validated below -40°C and above 120°C and exposed to 720 hours of salt spray, with extensive dimensional and material analysis for OE-to-aftermarket compatibility.
OE-matched material integrity: 100% crack detection and ultrasonic flaw detection ensure materials match OE specifications.
Precision ball studs: machined to micron tolerances for durable, smooth joint operation.
Consistent build: robot welding for repeatable quality, plus anti-corrosion protection applied to each part for corrosion prevention and enhanced aesthetics.
If a worn ball joint or control arm bushing is behind clunking over bumps, uneven tire wear, or loose steering, this assembly replaces the failed original. Delphi control arm reviews often note the brand's OE-grade engineering.
It's a direct-fit replacement for the 2001-2003 Kia Rio. Check the Buyer's Guide tab to confirm your exact vehicle.
What position is this control arm and ball joint assembly?
It is the front right (passenger-side) lower control arm with an integrated ball joint.
What are signs this part may need replacing?
Clunking over bumps, uneven tire wear, or loose or wandering steering can point to a worn control arm bushing or ball joint. Diagnose the cause before replacing.
How is the Delphi TC2487 built and tested?
Delphi uses 100% crack and ultrasonic flaw detection to match OE specifications, ball studs machined to micron tolerances, and robot welding, with anti-corrosion protection applied to each part.
Should I replace both sides at once?
This listing is for one assembly. For balanced suspension and steering, many technicians inspect and service the opposite side as part of the repair.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC2487
The Delphi control arm TC5177 pairs the lower control arm and ball joint in one front-left assembly, giving the 2004-2009 Nissan Quest a factory-style pivot point that locates the wheel and lets the...
Locate and support your front wheel with the Delphi control arm TC6248, a FRONT RIGHT UPPER control arm and ball joint assembly built as a direct-fit replacement for the 2005-2006 Ford Expedition and...
Keep steering precise and the suspension properly located with the Delphi control arm and ball joint assembly, MPN TC9497. It combines the control arm with an integrated ball joint in one direct-fit...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Restore precise wheel location and steering feel with the DELPHI control arm and ball joint assembly, part number TC8972. This front right lower unit drops in as a direct-fit replacement for the 2013...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
