Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:520-520
Dorman 520-995 front left upper lateral link and ball joint assembly for the 2005-2011 Audi A6 and other vehicles joins the wheel end to the chassis and lets the front suspension move. This control arm and ball joint assembly is a direct replacement for the original equipment on specific vehicle applications.
A worn assembly can show up as a clunk over bumps, loose or wandering steering, or uneven tire wear. Other suspension parts can produce similar symptoms, so first look at the rubber bushings and the ball joint for cracks, tears or leaking grease with the engine off. This listing is one assembly for the front left; the right side is a separate part, and both sides are normally replaced together.
The 2005-2011 Audi A6, the 2005-2011 Audi A6 Quattro and the 2007-2011 Audi S6 are covered by this part, along with other vehicles, and the quantity is one for the front left position.
Fit and size
Build and materials
One lateral link and ball joint assembly with mounting hardware. A grease fitting is not included.
Interchange: 102-5967
TC1827 · CA2145 · 2CB70031 · CK620621 · RK620621 · FA4622 · GS70111 · CMS70111 · 2605727 · SRK620620 · 1526025 · JTC1138 · 4E0407509B · 4E0407509E · 4E0407509G · 4E0407509K
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Does the Dorman 520-995 fit the 2005-2011 Audi A6 Quattro?
Yes. Dorman 520-995 is a front left upper rearward part for the 2005-2011 Audi A6 Quattro. If your car is not named here, look it up in the "Vehicles it fits" section.
Does the Dorman 520-995 lateral link assembly come with a grease fitting?
No. Dorman 520-995 has no grease fitting included. It is pre-greased, and it comes with mounting hardware and the ball joint and bushings already installed.
What are the bushings made of on this front left upper lateral link?
The bushings are rubber, and the arm is casting/forged steel. Additional coatings give it rust and corrosion resistance.
What size is the ball joint thread on Dorman 520-995?
The ball joint thread diameter is 14 mm. The stud is a pinch type 14.9 mm long, and the mounting hole measures 12.3 mm.
Does Dorman 520-995 replace part number 4E0407509B?
Yes. 4E0407509B is one of the numbers Dorman 520-995 replaces, along with 4E0407509E, 4E0407509G and 4E0407509K.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.