Mevotech Supreme Suspension Control Arm and Ball Joint Assembly P/N:CMS861195
Mevotech Supreme CMS501338 front right upper control arm with ball joint for the 2019-2025 Chevrolet Silverado 1500 and other vehicles locates the wheel and carries the ball joint. This Mevotech Supreme suspension control arm comes with the ball joint, bushings and dust boot.
Clunking over bumps, loose steering or uneven front tire wear can mean this control arm and ball joint assembly is worn, though a worn tie rod end or a tired front shock can be behind them too. If this arm is the cause, the assembly replaces the arm, ball joint and bushings in one piece.
This front right upper arm fits the 2019-2025 Chevrolet Silverado 1500, the 2019-2025 GMC Sierra 1500 and the 2021-2026 Chevrolet Tahoe, and each takes one. This listing is one arm for the front right; the front left upper is a separate part, and the pair on that axle is normally done at the same time. Own a different vehicle? Run your year and model through the "Vehicles it fits" section.
Fit and size
Build and materials
One control arm with ball joint, bushings, dust boot and mounting hardware.
Interchange: 527-418
19468650 · 84437972 · 84646950 · 85660607 · CB92168 · 2608765 · 8CB503208
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Will this Tahoe control arm fit a 2021-2026 Chevrolet Tahoe?
Yes. Mevotech Supreme CMS501338 is a front right upper control arm with ball joint that fits the 2021-2026 Chevrolet Tahoe. For a different year or vehicle, search the "Vehicles it fits" section.
Is this one of the Silverado 1500 control arms for the 2019-2025 Chevrolet Silverado 1500?
Yes. This front right upper arm fits the 2019-2025 Chevrolet Silverado 1500, one per application. The front left upper arm is a separate part.
What hardware comes with the Mevotech Supreme control arm?
Mevotech Supreme CMS501338 includes the ball joint, rubber bushings, dust boot, mounting hardware, a 180 degree SAE grease fitting and a part-specific nylon locking nut.
What are the bearing and dust boot on this front upper control arm made of?
The bearing is sintered metal and the dust boot is neoprene. The control arm itself is steel, and the bushings are rubber.
How can I tell if the ball joint on a front upper control arm is worn?
With the engine off, look for a torn dust boot or leaking grease, and notice clunks over bumps or loose steering while driving. A shop can test ball joint play safely.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.