Delphi Suspension Control Arm Bushing P/N:TD755W
Help reduce noise and vibration in the rear suspension with the Delphi TD983W, a control arm bushing for the 1996-2001 Audi A4 and 1997-2004 Audi A6. It is a direct-fit replacement for the rear position on these applications, designed by Delphi to OE standards. See the "Vehicles it fits" section for engine-specific fitment.
A suspension control arm bushing is the pivot point between the control arm and its mounting point. It lets the arm move with the suspension while helping cushion the chassis from road shock, so the arm stays properly located as the wheel travels.
Signs this part may need replacing include clunking or knocking from the rear suspension over bumps, loose or wandering handling, uneven tire wear, and visibly cracked or torn bushing material. Other suspension components can cause similar symptoms, so diagnose the cause before replacing. If a worn rear control arm bushing is the cause, the TD983W replaces it.
Interchange: 8D0 501 541 D
8D0501541D · 532234 · K201099 · JBU1993
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is the Delphi TD983W a 1997-2004 Audi A6 control arm bushing?
Yes. It is a direct-fit rear control arm bushing for the 1997-2004 Audi A6, and it also fits the 1996-2001 Audi A4. See the "Vehicles it fits" section for engine-specific fitment.
What does a control arm bushing do?
It is the pivot point between the control arm and its mount. It lets the arm move with the suspension while helping reduce the noise and vibration that reach the cabin.
What comes with the Delphi TD983W?
Delphi supplies the necessary accessories for the installation along with the TD983W bushing.
What are signs of a worn control arm bushing?
Clunking over bumps, loose or wandering handling, uneven tire wear, or cracked, torn bushing material may point to wear. Diagnose first, since other suspension parts can cause similar symptoms.
How does Delphi test its parts?
Delphi tests its parts at temperatures below -40°C and above 120°C and exposes them to 720 hours of salt spray. It also uses dimensional and material analysis to match the original part.
No reviews yet — be the first to review this product.
Write a ReviewWARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.