Firm up steering response and quiet your front end with the Delphi Suspension Control Arm Bushing TD4231W — Crown Victoria control arm bushings built as a direct-fit replacement for the 2003-2011 Ford Crown Victoria (see the Buyer's Guide tab for engine details). This is the front left lower rearward bushing, cushioning the control arm where it pivots against the chassis to isolate road vibration and help hold suspension geometry.
Delphi applies its OE engineering to the aftermarket, backed by extensive dimensional and material analysis for close compatibility between the OE and aftermarket part.
- Designed to OE standards for a suspension control arm bushing that fits and functions like the original.
- Manufactured for consistent life and to reduce noise, and made to reduce vibration through the pivot.
- Includes the necessary accessories for a complete job.
- Tested to the extreme — withstands temperatures below -40°C and over 120°C and endures 720 hours of salt spray.
If worn, cracked, or separated bushings are behind clunking, imprecise steering, or uneven tire wear on your car, replacing this Ford Crown Victoria control arm bushing addresses that pivot point. Diagnose the cause before ordering, and inspect matching bushings on the opposite side.
Interchange: 523-669 · 4W7Z 5A486-AA
523669 · 4W7Z5A486AA · BC5343 · BC5343PR · K80833 · K80835 · GS40400 · MS40400
This part cross-references / interchanges with the following part numbers:
523-669, 4W7Z 5A486-AA, BC5343, BC5343PR, K80833, K80835, GS40400, MS40400
