Dorman - OE Solutions Steering Knuckle Kit,Wheel Bearing and Hub Assembly P/N:686-433
Dorman 686-255 front left steering knuckle assembly for the 2012-2017 Toyota Camry and other vehicles mounts the wheel hub and bearing at the front left wheel as one pre-assembled unit. It comes loaded, with the critical components already assembled.
A worn wheel bearing can show up as a hum or growl from the front left that changes with speed. Worn tires, a warped brake rotor or a loose suspension joint can be behind a noise or vibration too, so find the cause before you buy.
It fits the 2012-2017 Toyota Camry and the 2013-2018 Toyota Avalon, and each takes one on the front left. This listing is one knuckle; the front right is a separate part, and the other side of the front axle is normally done at the same time.
Fit and size
Build and materials
One steering knuckle assembly and one axle nut. The axle, mounting hardware and an instruction manual are not included; plan on new bolts, since the old ones may not be reusable.
Interchange: 9692300 · LK047 · SK686255 · 4321206240 · 43502AA021 · 4778206130 · 9008036193 · WLK255
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this the front left 2012-2017 Toyota Camry steering knuckle?
Yes. Dorman 686-255 is a front left steering knuckle assembly for the 2012-2017 Toyota Camry and the 2013-2018 Toyota Avalon, one per side.
Does this Dorman steering knuckle include the axle nut and axle?
Dorman 686-255 comes with one axle nut, but the axle is not included. Mounting hardware and an instruction manual are not included either.
Is this steering knuckle kit made of steel, and is it painted?
Yes. The knuckle is steel with a painted finish, and its spline quantity is 30.
How do I know a front left wheel bearing and hub assembly is wearing out?
A hum or growl that changes with speed, or a vibration you feel while driving, can point to a worn bearing. A shop can confirm it.
Do I need a hydraulic press to install this loaded knuckle?
No. The Dorman 686-255 comes pre-pressed with its components assembled, so no hydraulic press is needed for the bearing repair.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.