Keep the transmission planted and quiet with the Anchor Automatic Transmission Mount, MPN 2828. This rear transmission mount helps support and locate the powertrain while dampening the vibration that travels into the chassis, and it drops in as a direct-fit replacement for the 1993-1998 Jeep Grand Cherokee — see the Buyer's Guide tab for the full engine-level application list.
Anchor engineers and designs its mounts to OE standards using a CAD/CAM process for consistent quality.
- Bonded rubber-to-metal: Chemlock® bonding agent is used for a strong rubber-to-metal bond.
- Application-tuned rubber: Natural and Styrene Butadiene rubber resists wear and stays stable as it ages, molded to a specific Durometer (hardness) based on the vehicle application.
- Hardware: Any included fasteners are hardened steel with heat-treated Grade #5 bolts.
Worn engine or transmission mounts often show up as vibration at idle, or a clunk on acceleration, deceleration, or shifting, along with cracked or separated rubber. If a failed rear transmission mount is the cause, this replaces it.
Interchange: 017-6534-6
6201526 · 313938 · MT2828 · 6949 · A2828 · 3080027 · 52058488 · 621041 · B2828 · 2906181 · EM2828 · 01765346
This part cross-references / interchanges with the following part numbers:
Manufacturer's Warranty: 12 Month Warranty.
Frequently Asked Questions
What does this mount do?
It helps support and locate the powertrain while dampening vibration, so less engine and transmission movement and noise transfer into the chassis. It is the rear transmission mount.
Which vehicles does it fit?
It is a direct-fit replacement for the 1993-1998 Jeep Grand Cherokee. Check the Buyer's Guide tab to confirm the engine-level fit for your vehicle.
What are signs I may need to replace it?
Common signs include vibration at idle, a clunk on acceleration, deceleration, or shifting, and rubber that is cracked or separated. Diagnose the cause before replacing.
What is the mount made of?
It uses natural and Styrene Butadiene rubber bonded to metal with Chemlock® bonding agent, molded to a specific Durometer hardness based on the vehicle application.
Are fasteners included?
Any included fasteners are hardened steel with heat-treated Grade #5 bolts. Consult the vehicle service information for the correct fasteners and whether they may be reused.
Write a Review