Anchor Drive Shaft Center Support Bearing P/N:6076
$49.99
(You save)
Keep your driveshaft spinning smoothly and quietly with the Anchor Drive Shaft Center Support Bearing 6076. This center support mounts the driveshaft between the transmission and differential, holding it in position and helping relieve stress on driveline components. It's a direct-fit replacement for the 2001-2007 Ford Escape, 2001-2006 Mazda Tribute, and 2005-2007 Mercury Mariner, and it's engineered and designed to OE standards using a CAD/CAM process for consistent quality.
Vibration damping: a high-grade rubber cushion maximizes dampening of vibration and helps absorb overloads.
Durable housing: a heavy-gauge steel housing frame built to extend service life.
Strong rubber-to-metal bond: natural and Styrene Butadiene rubber that resists wear and stays stable as it ages, with a Chemlock® bonding agent for a superior rubber-to-metal bond.
Ready to install: most center supports include a sealed bearing and dust shield. When fasteners are included, they are hardened steel with heat-treated Grade-5 bolts.
Worn center support bearings often show up as vibration, humming, or a rumble that changes with speed, or as movement felt through the floor. If a failed center support is the cause, this unit replaces it.
This part cross-references / interchanges with the following part numbers:
A6089, 934201, HB202510, 1525, DS6076
Manufacturer's Warranty: 12 Month Warranty.
Frequently Asked Questions
What does this center support bearing do?
It supports the driveshaft between the transmission and differential, holding it in position and helping relieve stress on driveline components while damping vibration.
Which vehicles does the Anchor 6076 fit?
It's a direct-fit replacement for the 2001-2007 Ford Escape, 2001-2006 Mazda Tribute, and 2005-2007 Mercury Mariner. Check the Buyer's Guide tab to confirm your vehicle.
What are the signs of a failing center support bearing?
Common signs include vibration, humming or a rumble that changes with speed, and movement felt through the floor. Diagnose the cause before replacing.
What is the housing and rubber made of?
The housing frame is heavy-gauge steel, and the cushion uses natural and Styrene Butadiene rubber bonded with a Chemlock® bonding agent for a strong rubber-to-metal bond.
Does it include mounting fasteners?
Most units are ready to install with a sealed bearing and dust shield. When fasteners are included, they are hardened steel with heat-treated Grade-5 bolts; consult the service information for correct fasteners.
Write a Review
Anchor
Anchor Drive Shaft Center Support Bearing P/N:6076
Keep the driveshaft turning smoothly and cut driveline vibration with the Anchor Drive Shaft Center Support Bearing 6035, a CENTER-mounted support that carries the driveshaft between the transmission...
Keep your driveshaft spinning smoothly and take the load off your driveline with the Anchor Drive Shaft Center Support Bearing 6040. Mounted at the center position, it supports the driveshaft between...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
