Anchor Drive Shaft Center Support Bearing P/N:6105
$94.99
(You save)
Steady a spinning driveshaft and quiet driveline vibration with the Anchor Drive Shaft Center Support Bearing 6105. It installs as a direct-fit replacement for the 2011-2016 Chevrolet Caprice [All] and 2014-2016 Chevrolet SS [All], mounting in the center of the driveline to support the driveshaft between the transmission and differential and relieve stress on driveline components.
Sealed bearing: The center support carries a sealed bearing set into the support housing.
Vibration-damping cushion: A high-grade rubber cushion dampens vibration and helps absorb overloads. Built from natural and Styrene Butadiene (SBR) rubber, it resists wear and stays stable as it ages.
Strong bond and frame: A Chemlock® bonding agent creates a strong rubber-to-metal bond, and the housing frame is made from heavy-gauge steel that extends service life.
Key dimensions: 30 mm (1.1811 in) inside diameter, 187 mm (7.38 in) bolt-hole center-to-center, and 63 mm (2.48 in) center-line to mounting surface. Country of origin: Taiwan.
A worn center support bearing can show up as driveline vibration, a whine or rumble from under the vehicle, or a clunk on acceleration. If a failed center support bearing is the cause, this unit replaces it.
Interchange: A60015 · 934680 · 7537 · DS6547
This part cross-references / interchanges with the following part numbers:
A60015, 934680, 7537, DS6547
Manufacturer's Warranty: 12 Month Warranty.
Frequently Asked Questions
What does a drive shaft center support bearing do?
It supports the driveshaft between the transmission and differential, letting it spin smoothly while relieving stress on driveline components and helping dampen vibration.
Which vehicles does the Anchor 6105 fit?
It is a direct-fit replacement for the 2011-2016 Chevrolet Caprice [All] and 2014-2016 Chevrolet SS [All]. Check the Buyer's Guide tab to confirm fitment for your vehicle.
Does this center support bearing come with a sealed bearing?
Yes. The center support carries a sealed bearing mounted in the support housing.
What are the signs my center support bearing needs replacing?
Common signs include driveline vibration, a whine or rumble from under the vehicle, and a clunk on acceleration. Diagnose the cause before replacing.
What is the rubber cushion made of?
It uses a high-grade rubber cushion of natural and Styrene Butadiene (SBR) rubber that dampens vibration, helps absorb overloads, resists wear, and stays stable as it ages.
Write a Review
Anchor
Anchor Drive Shaft Center Support Bearing P/N:6105
Keep the driveshaft turning smoothly and cut driveline vibration with the Anchor Drive Shaft Center Support Bearing 6035, a CENTER-mounted support that carries the driveshaft between the transmission...
Keep your driveshaft spinning smoothly and take the load off your driveline with the Anchor Drive Shaft Center Support Bearing 6040. Mounted at the center position, it supports the driveshaft between...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
