Anchor Drive Shaft Center Support Bearing P/N:8532
$69.99
(You save)
Quiet a vibrating driveline and keep a two-piece driveshaft properly supported with the Anchor Drive Shaft Center Support Bearing 8532. It installs as a direct-fit replacement for the 1984-1988 Toyota Pickup [All], mounting at the center of the driveline where the front and rear shaft sections meet.
A center support bearing carries the driveshaft between the transmission and differential and helps isolate the vibration those spinning shafts create. Signs the original may need replacing include driveline vibration, humming or growling that changes with speed, and cracked or separated rubber.
Supports the driveshaft: locates the shaft between the transmission and differential to relieve stress on driveline components.
Sealed bearing: a round, sealed bearing with dust shield, ready to install.
Rubber cushion: natural and Styrene Butadiene rubber dampens vibration and helps absorb overloads, with a Chemlock® bonding agent for a strong rubber-to-metal bond.
Heavy-gauge steel housing: the frame is built from heavy-gauge steel; any included fasteners are hardened, heat-treated Grade-5 bolts.
Key specs: 30 mm (1.1811 in) inside diameter and 152 mm (6 in) bolt-hole center-to-center spacing. Country of origin: Thailand. Backed by a 12-month warranty.
It supports the driveshaft between the transmission and differential, locating the shaft and relieving stress on driveline components while dampening vibration.
Which vehicle does the Anchor 8532 fit?
It is a direct-fit replacement for the 1984-1988 Toyota Pickup [All]. Confirm your application in the Buyer's Guide tab before ordering.
Is the bearing sealed and ready to install?
Yes. It uses a round, sealed bearing with a dust shield and comes ready to install.
What are the signs my center support bearing is failing?
Watch for driveline vibration, humming or growling that changes with speed, and cracked or separated rubber. Have the cause diagnosed before replacing.
What are the key dimensions?
It has a 30 mm (1.1811 in) inside diameter and 152 mm (6 in) bolt-hole center-to-center spacing. Country of origin is Thailand.
Write a Review
Anchor
Anchor Drive Shaft Center Support Bearing P/N:8532
Keep the driveshaft spinning smooth and quiet with the Anchor Drive Shaft Center Support Bearing 6062, the CENTER support that holds and steadies the driveshaft between the transmission and...
Keep your driveshaft spinning smoothly and take the load off your driveline with the Anchor Drive Shaft Center Support Bearing 6040. Mounted at the center position, it supports the driveshaft between...
Keep the driveshaft turning smoothly and cut driveline vibration with the Anchor Drive Shaft Center Support Bearing 6035, a CENTER-mounted support that carries the driveshaft between the transmission...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
