Quiet driveline vibration and keep your gearbox properly located with the Anchor transmission mount (P/N 10008), a direct-fit replacement for the left-side manual transmission mount. It drops in on the 2014-2016 KIA RONDO and the 2014-2019 KIA SOUL — see the Buyer's Guide tab for engine-level fitment.
This mount helps support and locate the transmission while dampening vibration passed into the chassis. Anchor engineers each mount to OE standards using a CAD/CAM process for consistent quality.
- Left-side fit: cataloged for the LEFT manual transmission mount position on the listed KIA applications.
- Rubber that lasts: built from natural and Styrene Butadiene rubber that resists wear and stays stable as it ages.
- Strong bond: Chemlock® bonding agent creates a superior rubber-to-metal bond, and the rubber is made to a specific Durometer (hardness) based on the vehicle application.
- Hardware: any included fasteners are hardened steel, heat-treated Grade 5 bolts.
Signs a mount may need replacing include clunks on acceleration, deceleration or shifting, vibration at idle, and cracked or separated rubber. If a worn transmission mount is the cause, this replaces it.
Interchange: A71066 · 218303Z000 · B71066 · 3259 · EM7362
This part cross-references / interchanges with the following part numbers:
Manufacturer's Warranty: 12 Month Warranty.
Frequently Asked Questions
Will this Anchor transmission mount fit my vehicle?
It is a direct-fit replacement for the 2014-2016 KIA Rondo and 2014-2019 KIA Soul. Check the Buyer's Guide tab to confirm the engine-level fitment for your vehicle.
What position is P/N 10008?
It is cataloged as the LEFT-side manual transmission mount for the listed KIA applications.
What does a transmission mount do?
It helps support and locate the transmission while dampening vibration so less noise and movement reach the chassis.
How do I know my transmission mount is worn?
Common signs include clunks on acceleration, deceleration or shifting, vibration at idle, and cracked or separated rubber. Diagnose the cause before replacing.
What is the mount made of?
It uses natural and Styrene Butadiene rubber bonded to metal with Chemlock® agent, molded to a specific Durometer hardness for the application.
Write a Review