Keep the exhaust on your Jeep flowing and help control tailpipe emissions with the AP Exhaust Catalytic Converter 645269, a Federal/EPA direct-fit converter built to slot into the factory location on the 2007-2009 Jeep Wrangler (V6-3.8L). It reduces regulated pollutants in the exhaust stream as the gases pass through the catalyst-coated substrate, and its direct-fit design is made to match the original converter's connections for a straightforward installation.
This is a Federal/EPA converter that is not CARB certified, so it is not intended for sale or use on vehicles registered in California or other states requiring CARB-compliant converters. Made in the United States.
Interchange: 52059930AH
This part cross-references / interchanges with the following part numbers:
Will this converter fit my vehicle?
It is a direct-fit converter for the 2007-2009 Jeep Wrangler with the V6-3.8L engine. Check the Buyer's Guide tab and confirm your engine before ordering.
Is this converter CARB certified?
No. It is a Federal/EPA converter and is not CARB certified, so it is not intended for sale or use on vehicles registered in California or other CARB states.
What is the converter made of?
It uses 409 stainless steel shell and neck construction with a ceramic substrate and Aristo Clean by Design catalyst technology.
Does it include installation hardware and gaskets?
Outlet hardware is included, but no inlet hardware is supplied. The inlet and outlet gaskets are listed as not required for this converter.
What are the inlet and outlet connections?
It has dual 2-bolt loose flange inlets with a spherical flare, a 2.50 OD outlet pipe, and four sensor ports. Overall length is 44 inches.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
