Arnott Industries Suspension Strut and Coil Spring Assembly P/N:SK-2954
$252.99
(You save)
Firm up ride quality and quiet a worn-out front corner with the Arnott Industries Suspension Strut and Coil Spring Assembly SK-2954, a pre-assembled front coil-over strut that installs as a direct-fit replacement on GMT900-platform trucks and SUVs equipped with electronic suspension: the 2007-2014 Cadillac Escalade, 2007-2014 Chevrolet Suburban 1500, 2007-2014 Chevrolet Tahoe, 2007-2014 GMC Yukon, 2007-2014 GMC Yukon XL 1500, and 2008-2014 Cadillac Escalade ESV. See the Buyer's Guide tab for engine-level fitment.
This complete strut and coil spring assembly fits the left or right front side and arrives ready to bolt in, so there's no spring compressing on the bench.
Pre-assembled for safety: ships with a steel coil spring (Code 6DA, 7DA), upper shock mount, bump stop, spring seat and isolator.
Custom-valved coil-over: an Arnott-designed passive alternative for aging air or electronic suspension, valved to help restore ride comfort.
Converts active to passive: an exclusive sensor plugs into the electronic-damping system to help eliminate dash error messages.
Includes spring seat, isolator and mounting hardware; an installation manual is available. For best results, Arnott recommends replacing in pairs.
Frequently Asked Questions
What is included with the SK-2954 assembly?
It ships pre-assembled with a steel coil spring (Code 6DA, 7DA), upper shock mount, bump stop, spring seat, isolator and mounting hardware, so no spring compressing is needed.
Which vehicles does this front strut fit?
It's designed for the 2007-2014 Escalade, Suburban 1500, Tahoe, Yukon and Yukon XL 1500, plus the 2008-2014 Escalade ESV. Check the Buyer's Guide tab for engine-level fitment.
Can I use this on the left or right side?
Yes. This strut assembly is designed to fit the left or right front side.
Will it stop the suspension warning messages on my dash?
Arnott's exclusive design includes a sensor that plugs into the electronic-damping system to help eliminate dash panel error messages when converting from active to passive suspension.
Should I replace both front struts at the same time?
For best results, Arnott recommends replacing in pairs so both front corners perform consistently.
Write a Review
ARNOTT
Arnott Industries Suspension Strut and Coil Spring Assembly P/N:SK-2954
Keep your Audi's front-left corner settled and controlled with the Arnott Industries Suspension Strut and Coil Spring Assembly (SK-3843), a pre-assembled strut and coil spring unit that drops into...
Smooth out a worn front corner and restore ride comfort with the Arnott Industries Suspension Strut and Coil Spring Assembly (SK-3794), a pre-assembled front right unit that installs as a direct-fit...
Smooth out the ride and steady the front corner of your Mercedes-Benz SL-Class (R231) with the Arnott Industries Suspension Strut and Coil Spring Assembly, MPN SK-3602 (also written SK3602). This...
Arnott offers a rear right coil strut assembly designed for 2018–2021 Lincoln Navigator (U554) and Ford Expedition (U553) models, including both short wheelbase (SWB) and long wheelbase (LWB)...
Refresh worn electronic dampers with the Arnott Industries Suspension Strut and Coil Spring Assembly SK-4261 (also written SK4261), a front, fully pre-assembled complete strut and coil spring...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
