Beck/Arnley CV Joint Boot Kit P/N:103-2751
Keep the grease in and the road grit out of your outer CV joint with the Beck/Arnley CV joint boot kit, part number 103-2110. It is an application-specific kit that supplies the boot, grease and clamps for the job. It fits many vehicles, among them the 1980-1992 Volkswagen Jetta, 1991-1992 Volkswagen Passat and 1985-1992 Volkswagen Golf. See the "Vehicles it fits" section for the full list.
Beck/Arnley designs its parts as direct replacements for OE applications across foreign nameplates, with close attention to form, fit and function. Its product specialists work with a trusted global sourcing network to deliver OE-quality parts, and every part is held to Beck/Arnley requirements and specifications.
A CV boot seals the joint, holding its grease in and keeping water and dirt out. This kit is cataloged for outer CV joint positions, front outer or rear outer depending on the application. Signs a boot may need replacing include a torn or split boot, grease flung around the inner wheel area, or loose clamps. If the joint already clicks when turning, the joint itself may be worn and need attention beyond a new boot.
Interchange: 361009 · 361010 · 171498203 · 321498203 · 191498203C · 862225K · 614494 · A9013 · CV2470 · CV2470SB · 661231 · DX702 · 61001X · 61231X · 8359173 · 22310 · 22312 · 224164 · 22431 · 10016
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
What comes with this Beck/Arnley CV boot kit?
The kit includes the boot, grease and clamps. The supplied grease contains an extreme pressure additive.
Is this the right CV joint boot kit for a 1980-1992 Volkswagen Jetta?
Yes. Part 103-2110 is listed for the 1980-1992 Volkswagen Jetta and the 1985-1992 Volkswagen Golf. Check the "Vehicles it fits" section for the full fitment chart.
Which CV joint position is this boot kit for?
It is cataloged for outer CV joint positions, either front outer or rear outer depending on the application.
Can I install this boot with a boot-stretching tool?
No. Beck/Arnley notes this boot is not intended for installation tools that stretch the small end of the boot over the CV joint.
What are signs a CV boot may need replacing?
Common signs include a torn or split boot, grease sprayed around the wheel area, or loose clamps. If the joint clicks when turning, it may be worn, so inspect it before installing a new boot.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.